JVC RX-TD77R Press the Surround Control button, Press the PRO Logic button, Select the Delay time

English

Perform the steps below using the buttons on the Remote Control.

SURROUND

CONTROL 1. Press the SURROUND CONTROL button.

PRO	2.	Press the PRO LOGIC button.
LOGIC
2
		“PRO LOGIC” appears on the display and the SURROUND indicator lights up.

SURROUND

CENTER	3.	Select the desired Center Speaker mode.
MODE
		Press the CENTER MODE button. The display changes with each press of the button, as shown
		below.
		= NORMAL = WIDE = OFF= PHANTOM = (back to the beginning)

DELAY			4.	Select the Delay time.
				Press the DELAY button. The display changes with each press of the button, as shown below.
7
				= DELAY 1 = DELAY 2 = DELAY 3 = (back to the beginning)
				Set the volume to the level you normally use.
			5.
				Press the TEST TONE button.
	TEST		6.
	TONE			A test tone is emitted in the order shown below.
1
				= LEFT = CENTER = RIGHT = REAR = (back to the beginning)
				When “PHANTOM” is selected for Center Speaker mode, the test tone for the center speaker is
				projected by the front speakers.
				When “OFF” is selected for Center Speaker mode, no test tone is output from the center speaker.
				Adjust the level for the center speaker.
CENTER			7.
LEVEL				Press the CENTER LEVEL + or – button. Set the level so that it is about the same as the level from
5		6
				the front speakers.

You cannot adjust the level for the center speaker if “PHANTOM” or “OFF” is selected for Center Speaker mode.

	REAR		8.	Adjust the level for the rear speakers.
LEVEL				Press the REAR LEVEL + or – button. Set the level so that it is about the same as the level from the
8		9
				front speakers.

TEST	9.	To cancel Test Tone mode.
TONE		Press the TEST TONE button again.
1
		This completes the preparations required for using Dolby Pro Logic.
	Note: The Dolby Pro Logic mode is not used with other surround modes. When the Dolby Pro Logic
	mode is turned on, the other surround mode, if used, will be turned off.

18