JVC DD868EU SELECT STATION NAME CHARACTER, ENTER NEW CHARACTER, *, SELECT ITEM, ACCESS MANUAL CHANNEL SET SCREEN, SELECT NEW STATION, SWITCH STATIONS

52 EN
SUBSIDIARY SETTINGS (cont.)
SELECT STATION NAME
CHARACTER
1
Press # until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press %fi to cycle through the characters (A–Z, 0–9, –,
*, +, (space) ) and stop when the desired character
is indicated, then press # to enter. Enter the remaining
characters the same way (maximum of 4).
After entering all characters, press OK.
●The Confirmation screen appears.
●If you make a mistake, press @ until the incorrect
character begins blinking. Then enter the correct
character by pressing %fi.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 50 to access the Confirmation screen before continuing.
SELECT ITEM
1
Press %fi @ # until the item you want begins blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
Press # until the station
name (ID) begins blinking,
then press %fi until the
new station’s name (ID)
you want to store begins
blinking.
Registered station names
(Z pg. 53) appear as you
press %fi.
SWITCH STATIONS
4
Press OK.
●The Confirmation screen appears.
●Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 50 to access the Confirmation screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your recorder.
PR CH ID FINE DECODER
06 CH45
– –– – +/– OFF
[5∞] : CHANGE ID
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞
PR CH ID FINEDECODER
06 CH45 ARD +/– OFF
[5∞] : A-Z, 0-9
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞