Brookhaven Direct Vent Gas Fireplace
Installation of Logs
The logs are fragile and should be handled with care. Keep the packaging material out of the reach of children and dispose of the mterial in a safe manner.
The individual logs can be easily identified by the numbers cast on the underside of each log.
Log Identification Chart
LOGS | 20DVT |
Log Rear | J11 |
Log Front | J12 |
|
|
Log Installation
1.Remove cast front assembly.
2.Remove window frame assembly.
3.Remove log box from inside firebox.
4.Unpack the logs from packaging and remove each log from its wrapping material. Set aside the ember and the lava rock bags.
As with all plastic bags - these are not toys and should be kept away from children and infants.
5.Place the log rear (J11). Place the two under- side holes of the log over the two pin studs of the bracket on the left and right sides of the burner housing. (Fig. 31)
Figure 32
6.Place the log front (J12). Place the two underside holes of the log over the two pin studs of the bracket on the left and right sides of the front burner hous- ing. (Fig. 32)
7.Place ember material on top of burner. Scatter the ember material over the tiles on the front area of the burner housing. (Fig. 31) Do not pack the ember material. Separate it when unpacking and keep it in a fluffy and loose condition for more realistic ember effect.
8.Place large lava rock onto the two sides of the burner tray. (Fig. 31)
Do not place any of the lava rock material on the burner housing assembly.
Figure 31 | Log Rear (J11) |
Ember
Material
LG471
Lava Rock
Log Front (J12)
LG470
18 | 10009459 |
