EN
42
USING THE REMOTE CONTROL UNIT
●Make sure to set “S/AV INPUT” to “OFF” in the Menu
Screen (墌 pg. 35).
●When editing on a VCR equipped with a DV input
connector, an optional DV cable can be connected
instead of an S-Video cable and audio/video cable.
5If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE s on the remote control (墌 pg. 28,
43).
•Cycle through the effects by pressing repeatedly, and
stop when the one you want is displayed.
6At the beginning of the scene, press EDIT IN/OUT
g on the remote control. The Edit-In position appears
in the Random Assemble Editing Menu.
7At the end of the scene, press EDIT IN/OUT g. The
Edit-Out position appears in the Random Assemble
Editing Menu.
8If using a Fade/Wipe at the end of the scene, press
FADE/WIPE s (墌 pg. 28, 43).
•Cycle through the effects by pressing repeatedly, and
stop when the one you want is displayed.
•If you select a Fade/Wipe effect for an Edit-Out point,
the effect is automatically applied to the following
Edit-In point.
•When you use Fade/Wipe effects, that time is included
in the total time.
9If using Playback Special Effects, press EFFECT f
(墌 pg. 39).
10
Repeat steps 6 through 9 to register additional
scenes.
•To change previously registered points, press
CANCEL h on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
•If you are not using Fade/Wipe or Programme AE with
special effects, repeat steps 6 and 7 only.
NOTES:
●When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
●If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be cancelled
and editing will not take place.
●If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
●Since time codes register time only as accurately as
seconds, the time code total time may not match the total
programme time exactly.
●Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
●If you select Sepia or Monotone mode from Programme
AE with special effects, you cannot use the Black & White
Fader. In this case the Black & White indicator begins
blinking. Once the next Edit-In point is registered, the
effect is turned off. To combine these effects, use Sepia
or Monotone during recording, then use the Black &
White Fader during Random Assemble Editing.
●It is not possible to use Fade/Wipe effects and
Programme AE with special effects during Random
Assemble Editing using a DV cable.

f

g

s

U

D

J

h

To Remote PAUSE
or R.A.EDIT
TV
To PAUSE IN j
S-Video/Audio/Video/
Editing cable (provided)
*Connect when the S-Video connection is not used.
**When connecting cables, open this cover.
Connector
cover**
To S/AV &
VCR
To AUDIO, VIDEO*
and S-Video
connectors
SELECT SCENES
4Point the remote control at the camcorder’s remote
sensor. Press PLAY (
4
) D and then press R.A.EDIT
ON/OFF J on the remote control.
The Random Assemble Editing Menu appears.
Editing
Extension
cable
(provided)