JVC FS-V100 Changing the FM Reception Mode, Presetting stations automatically, a preset number

4 Press the UP, DOWN, > or < button within 5 seconds to select the preset number.

UP or > button: Increases the preset number by 1.

DOWN or < button: Decreases the preset number by 1.

•When the > or < button is held down, the preset number changes rapidly.

5Press the SET button within 5 seconds.

“STORED” appears and after 2 seconds, the display returns to the broadcast frequency display.

6Repeat above steps 1 to 5 for each station you want to store in memory with

a preset number.

To change the preset stations, repeat the same steps as above.

Presetting stations automatically –––

In each band, you can automatically preset 30 FM and 15 AM stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency and moving up the frequency.

AUTO

FM/AMPRESET

(For more than 2 seconds)

1Select a band by pressing the FM/AM button.

2Press the AUTO PRESET button on the Remote Control for more than 2 seconds.

3Repeat steps 1 – 2 for the other band.

■If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.

CAUTION:

Even if the system is unplugged or if a power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.

Changing the FM Reception Mode

When you have tuned into an FM stereo broadcast, the STEREO indicator lights up and you can hear stereo effects.

If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo effect.

Press the FM MODE button on the Remote Control so that the MONO indicator lights up on the display.

FM

MODE

STEREO MONO

To restore the stereo effect, press the FM MODE button on

the Remote Control so that the MONO indicator goes off.

9

EN01-09.FS-V100[J]f 9 12/12/00, 10:34 AM