1RS-232C CONTROL Input terminal (D-sub, 9-pin) (page 11)
Connect this terminal to the
•For the control method using this terminal, consult an authorized JVC dealer.
2AC INPUT terminal (page 11)
Connect the supplied power cord to this terminal.
3MAIN POWER switch (page 12)
Setting this switch to ON will put the Monitor into standby mode, allowing you to turn on and off the power using the POWER button either on the remote control or on the Monitor.
4REMOTE CONTROL terminals (mini jack) (page 24)
•IN
For Master Monitor: Connect a wired remote control to this terminal for serial connection.
For Slave Monitors: Connect to the REMOTE CONTROL OUT terminal of another Monitor in serial connection.
•OUT
Connect to the REMOTE CONTROL IN terminal of anther Monitor for serial connection.
5SPEAKER OUT terminals (page 11)
Connect external speakers.
6INTERNAL/EXTERNAL
INTERNAL: To use
EXTERNAL: To use external speakers.
7VIDEO A terminals (page 11)*
•Y/C (S video) input terminal (Y/C terminal)
Connect this terminal to the
•Video input terminal (BNC)
Connect this terminal to the video output terminal of a VCR, etc. You can also use it as a video output terminal.
•Video output terminal (BNC)
Connect this terminal to the video input terminal of another Monitor. You can also use it as a video input terminal.
•Audio input terminals (pin jack)
Connect these terminals to the audio input terminals of a VCR, etc.
8VIDEO B terminals (page 11)*
•Y/C (S video) input terminal (Y/C terminal)
Connect this terminal to the
•Video input terminal (BNC)
Connect this terminal to the video output terminal of a VCR, etc. You can also use it as a video output terminal.
•Video output terminal (pin jack)
Connect this terminal to the video input terminal of another Monitor.
You can also use it as a video input terminal.
•Audio input terminals (pin jack)
Connect these terminals to the audio output terminals of a VCR, etc.
Notes:
•Since the video output terminals on this Monitor are loop- though terminals, the devices connected to these video output terminals should be correctly terminated. Otherwise, picture becomes abnormally bright.
•When both the video and
9COMPONENT input terminals (page 11)*
•Y,
Connect these terminals to the component signal output terminals of NTSC or
•Audio input terminals (pin jack)
Connect these terminals to the audio output terminals of another equipment.
pRGB input terminals (page 11)
•PC input terminal
Connect this terminal to the video output terminal of a personal computer.
•Audio input terminals (pin jack)*
Connect these terminals to the audio output terminals of a personal computer.
ENGLISH
Note:
*
7