SOUND ADJUSTMENTS

Adjusting the sound

2 Make adjustments.

 

 

ENGLISH

You can set the speaker output balance, subwoofer output level, and input level of each source.

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

1 Select the item you want to adjust.

The next-step-operation buttons start flashing. Each time you press the button, the adjustable items change as follows:

•To adjust fader and balance—Fad, Bal: You can make these two adjustments at the same time.

•If you are using a two-speaker system, set the fader level to “00.”

• Press 5(up) or ∞(down) to adjust the fader.

•Press ¢ or 4 to adjust the balance.

iEQ

 

 

 

Fad/Bal

 

 

 

Sub Out

 

 

 

 

 

 

 

 

Canceled Theme Vol Adj

•For iEQ (sound mode) settings, see pages 25 – 27.

•For THEME (display theme) settings, see page 28.

Indication

To do:

 

Range

 

 

 

Fad

Adjust the front

R06 (Rear only)

 

and rear speaker

 

 

balance.

F06 (Front only)

Bal

Adjust the left

L06 (Left only)

 

and right speaker

 

 

balance.

R06 (Right only)

Sub Out

Adjust the

00

(min.)

 

subwoofer output

 

 

level and cutoff

12

(max.)

 

frequency level.

Low/Mid/High

Vol Adj

Adjust and store

–12 (min.)

 

the input level

 

 

of each source.

+12 (max.)

 

 

 

 

•To adjust subwoofer output—Sub Out: This takes effect only when a subwoofer is connected.

To increase the level

To decrease the level

You can also set an appropriate cutoff frequency level according to the subwoofer connected.

•Press ¢ or 4 to select “Low,” “Mid,” or “High.”

Low: Frequencies higher than 50 Hz are cut off to the subwoofer.

Mid: Frequencies higher than 80 Hz are cut off to the subwoofer.

High: Frequencies higher than 115 Hz are cut off to the subwoofer.

24