Basic Connections
1 CONFIRM
2 CONNECTVCR CAMCORDER TO TV OR
Pull out the connector cover and open it. Connect as shown in the illustration (☞ pg. 42).
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3 CONNECTINPUT VCR OUTPUT TO TV
Refer to your VCR’s instruction manual.
4 SUPPLY POWER
Turn on the camcorder, the VCR and the TV.
5 SELECT MODE
Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.
NOTES:
●It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack (☞ pg. 9).
●To monitor the picture and sound from the camcorder without inserting a tape, set the camcorder’s Power Switch to “CAMERA” (“AUTO” or “PRO.”), then set your TV to the appropriate input mode.
●Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.
●If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.
EN43
Tape Dubbing
CONNECT EQUIPMENT |
|
1 Following the illustration on pg. 42, connect the |
|
camcorder and the VCR. |
|
PREPARE FOR DUBBING |
|
2 Set the camcorder’s Power Switch to “PLAY”, |
|
turn on the VCR’s power, and insert the |
|
appropriate cassettes in the camcorder and the |
|
VCR. |
|
SELECT VCR MODE |
|
3 Engage the VCR’s AUX and |
|
modes. |
|
FIND |
|
4 Engage the camcorder’s Play mode to find a spot |
|
just before the |
|
press PLAY/PAUSE (4/6) on the camcorder. |
|
START EDITING |
|
5 Press PLAY/PAUSE (4/6) on the camcorder and | PLAYBACK |
engage the VCR’s Record mode. | |
STOP EDITING TEMPORARILY | |
6 Engage the VCR’s | |
PLAY/PAUSE (4/6) on the camcorder. |
|
7 EDIT MORE SEGMENTS |
|
