50ENCAUTIONS

(cont.)

3.DO NOT leave the unit . . .

..... in places of over 50°C.

..... in places where humidity is extremely low. (below 35%) or extremely high (above 80%).

..... in direct sunlight.

..... in a closed car in summer.

..... near a heater.

4.To protect the unit, DO NOT . . .

..... allow it to become wet.

..... drop the unit or strike it against hard objects.

..... subject it to shock or excessive vibration during transportation.

..... keep the lens directed at extremely bright objects for long periods.

..... direct the eyepiece of the viewfinder at the sun.

..... carry it by holding the viewfinder or the LCD monitor. Be sure to hold the main unit with both hands or use the grip.

..... swing it excessively when using the shoulder strap.

LCD monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

..... push it strongly or apply any shocks.

..... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

SPECIAL NOTES ON VIDEO HEADS

Dust and dirt on video heads

1.Always allow enough time for your camcorder to acclimatize to its environment before using it.

2.Do not use the unit in areas of high humidity. (Typical areas of high humidity are given below.) •From being used or stored in a very cold outdoor

situation, then immediately being used in a warm indoor situation.

•From being used or stored in a cool air-conditioned situation, then being used in a high-humidity outdoor situation.

•Other areas where rapid large temperature changes can occur.

3.Taking care of your “C” format video cassette tapes.

•Store the video cassette tapes in a vertical position, complete in their cassette cases.

•During transportation, always store cassettes in their cassette cases.

4.Check recorded information at regular intervals. If the camcorder is equipped with a quick review facility, use this facility to check whether the picture is clear or not.

If the quick review or playback picture is not clear, then the video heads may be dirty.

..... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use. These are not malfunctions . . .

While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

If you leave power on for a long time, the surface around the LCD monitor becomes hot.

About moisture condensation . . .

You may have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass’ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

NOTE:

As a maladjusted tracking control can give similar symptoms to dirty video heads, please check that the tracking control of the unit is in the centre position.

Cleaning the video heads

Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or interrupted. Although this camcorder is equipped with a built-in head cleaner which automati- cally cleans the heads, reducing the likelihood of dirty heads, if such troubles are encountered, we recom- mend the use of the cleaning cassette specifically designed for JVC camcorders, model number TCC-2U. Please use the cleaning cassette as indicated below:

1After inserting the cleaning cassette, activate the Play mode for a maximum of 15 seconds (normally, 5

seconds is sufficient).

2Remove the cleaning cassette and check the playback picture with a previously good-recorded

tape.

3If the picture is clear, then recording on a new tape

can begin when desired.

4If the picture is not clear, repeat steps 1 to 3 up to

two more times.

5If the picture is still unclear, consult your local JVC dealer.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

Important Note:

If heads have become dirty, the associated tape will also be damaged, please do not use the tape again.

•A built-in head cleaner automatically cleans the video heads and head drum whenever a cassette is loaded and unloaded to reduce head clogging.

•Cleaning cassette TCC-2U is available from your JVC local dealer.

Page 50
Image 50
JVC GR-AXM33 specifications Cont, Special Notes on Video Heads