JVC GR-AXM700 manual 82 EN, Troubleshooting

82EN

TROUBLESHOOTING(cont.)

When the System Select Switch is set to “D.S.C.”:

SYMPTOMPOSSIBLE CAUSE(S)

SHOOTING

Although the SNAPSHOT Button is	● When the number of remaining shots available reaches
pressed, a still image is not stored in	“0” (blinking), it becomes impossible to take your next
the built-in memory.	shot. Perform “DELETE” function to remove some still
	images already stored in memory (☞ pg. 60).
Self-Timer Shooting is not available.	● Pressing the Recording Start/Stop Button does not start
	recording in the Self-Timer Shooting procedure. Press the
	SNAPSHOT Button (☞ pg. 51).
It is not possible to shoot in	● A still image is in the process of being stored in memory
sucession.	for approx. 2 seconds after the SNAPSHOT Button is
	pressed. During that time, it is impossible to take another
	shot. When the still image disappears and the scene you
	are currently aimed at appears on the screen, take another
	shot (☞ pg. 48).
PLAYBACK
Although “ALL” is selected in the	● The “Protect” function is in effect for some still images. If
DELETE Menu Screen, all still images	they are not necessary, cancel the “Protect” function, then
cannot be deleted.	try deleting all still images again (☞ pg. 59).
OTHER
Date/Time Insert is not performed	● It is not possible to display the date/time on a still image.
while shooting a still image.
Instant Titles are not displayed while	● It is not possible to display the Instant Titles on a still image.
shooting a still image.
Some settings cannot be changed in	● It is not possible to set “REC TIME” in the Menu Screen.
the Menu Screen.

Since the camcorder is a microcomputer-controlled device, external noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. For example, when a still image you shot is stored in the camcorder's built-in memory, the above may cause the following: Although the remaining number of shots indicator shows that shooting is possible, a still image cannot be stored in memory after shooting.

In such a case, initialize the memory by following steps 1 through 3 below. Please note that initialization deletes all the still images (including ones for which you performed the “Protect” function) stored in the camcorder’s memory. If you wish to keep any of the still images that are stored in memory, before initialization first transfer them to a PC and save them. If image data is corrupt, transfer is impossible.

FORMAT

CANCEL

ENTER

Format Menu Screen

1.Set the System Select Switch to “D.S.C.”, then set the Power Switch to “PLAY”.

2.Press the MODE Button for more than 5 seconds. The FORMAT Menu Screen appears.

3.Rotate the MENU Jog Dial to move the highlight bar to “CANCEL” or “ENTER”, then press it.

•“CANCEL” does not initialize the memory.

•“ENTER” initializes the memory. During initialization, “ENTER” blinks. When initialization is complete, the screen becomes blue back.

CAUTION:

While “ENTER” is selected and it is blinking, switching off the camcorder or removing the power supply unit (battery pack or AC Power Adapter/Charger) may cause the camcorder’s built-in memory to become corrupt. Never remove the power supply unit at this stage.