JVC GR-D22 Power, ATTENTION, INFORMATION, Battery pack, BATT. RELEASE, Charging time, USING AC POWER, GETTING STARTED, USING THE BATTERY PACK, CHARGING THE BATTERY PACK

PowerCHARGING THE BATTERY PACK

1 With the arrow on the battery pack pointing upward, push the battery pack slightly against the battery pack mount !, then slide up the battery pack until it locks in place.

2 Set the Power Switch r to “OFF (CHARGE)”. Connect the AC Adapter to the camcorder.

3 Plug the AC Adapter into an AC outlet. The POWER/ CHARGE lamp w on the camcorder blinks to indicate charging has started.

4 When the POWER/CHARGE lamp w goes off, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

To Detach The Battery Pack:

Slide the battery pack down slightly while sliding down BATT. RELEASE i to detach it.

Battery pack	Charging time
BN-V408U	approx. 1 hr. 30 min.
BN-V416U (optional)	approx. 3 hrs.
BN-V428U (optional)	approx. 5 hrs.

Charging times are for a fully discharged battery pack.

USING THE BATTERY PACK

Perform step 1 of “CHARGING THE BATTERY PACK”.

Approximate recording time

Battery pack	LCD monitor on	Viewfinder on
BN-V408U	1 hr. 10 min.	1 hr. 40 min.
BN-V416U	2 hrs. 30 min.	3 hrs. 30 min.
(optional)
BN-V428U	4 hrs. 20 min.	6 hrs. 20 min.
(optional)
BN-V840U	5 hrs. 20 min.	7 hrs. 30 min.
(optional)
BN-V856U	8 hrs. 10 min.	11 hrs. 10 min.
(optional)

USING AC POWER

Connect the AC Adapter to the camcorder as shown in the following illustration.

•The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.

!w r

Arrow

Battery pack	To DC
	connector
		i
AC Adapter

To AC outlet

ATTENTION

Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.

INFORMATION

The extended-use battery pack kit is a set composed of a battery pack and AC Power Adapter/Charger:

VU-V840 KIT : BN-V840U battery pack & AA-V15U AC

Power Adapter/Charger

VU-V856 KIT : BN-V856U battery pack & AA-V80U AC

Power Adapter/Charger

Read the kit's instruction manual before using. Also, by using the optional JVC VC-VBN856U DC Cord, it will be possible to connect BN-V840U or BN-V856U battery packs to the camcorder and supply power directly to the camcorder.

NOTES:

●If the protective cap is attached to the battery pack, remove it first.

●During charging, the camcorder cannot be operated.

●Charging is not possible if the wrong type of battery is used.

●When charging the battery pack for the first time or after a long storage period, the POWER/CHARGE lamp w may not light. Remove the battery pack from the camcorder, then try charging again.

●If a fully-charged battery’s operation time remains extremely short, the battery is worn out. Please purchase a new one.

●Recording time is reduced significantly when Zoom or Record-Standby mode is engaged repeatedly or the LCD monitor is used repeatedly.

●Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.

Continued on next page.

EN

GETTING STARTED 7