●Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

●The following operation stops charging:

•Set the Power Switch r to “PLAY”, “” or “”.

•Disconnect the AC Adapter from the camcorder.

•Unplug the AC Adapter from the AC outlet.

•Detach the battery from the camcorder.

●This camcorder will be automatically turned off if its power is supplied from the AC adapter and about 5 minutes pass since it has entered into the recording standby mode with a cassette inserted. If, under those conditions, the battery is attached to the camcorder, its charging will start.

●Using the optional AA-V40U AC Power Adapter/Charger, you can charge the BN-V408U/V416U/V428U battery pack without the camcorder. However, it cannot be used as an AC adapter.

●To avoid interference with reception, do not use the AC Adapter near a radio.

●Perform charging where the temperature is between

10°C and 35°C (50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.

●Charging time varies according to the ambient temperature and the status of the battery pack.

Grip Adjustment

1 Separate the Velcro strip.

2 Pass your right hand through the loop and grasp the grip.

3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button ) and Power Switch r and Power Zoom Lever %. Be sure to fasten the Velcro strip to your preference.

%

r

)

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion.

WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

The Benefits Of Lithium-Ion Batteries

Lithium-ion battery packs are small but have a large power capacity. However, when one is exposed to cold temperatures (below 10°C/50°F), its usage time becomes shorter and it may cease to function. If this happens, place the battery pack in your pocket or other warm, protected place for a short time, then re-attach it to the camcorder. As long as the battery pack itself is not cold, it should not affect performance.

(If you’re using a heating pad, make sure the battery pack does not come in direct contact with it.)

Viewfinder Adjustment

1 Set the Power Switch r to “ ” or “” while pressing down the Lock Button e located on the switch.

2 Pull out the viewfinder fully and adjust it manually for best viewability.

3 Turn the Diopter Adjustment Control ( until the indications in the viewfinder are clearly focused.

PAUSE

(

Lithium-ion is vulnerable in colder temperatures.

e r

EN

8 GETTING STARTED