JVC GR-D350AG Power, Charging The Battery Pack, Slide the battery pack upward while pressing

Connect the AC Adapter to the camcorder.

To DC connector

To AC outlet

Power switch

AC Adapter

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount 1.

3 Slide down the battery pack until it locks in place 2.

Battery pack mount

12 EN GETTING STARTED

	Power	To detach the battery pack
		Slide the battery pack upward while pressing
This camcorder’s 2-way power supply system		PUSH BATT. to detach it.
lets you choose the most appropriate source of		Battery pack	Charging time
power. Do not use provided power supply units
		BN-VF707U*	Approx. 1 hr. 30 min.
with other equipment.
Charging The Battery Pack		BN-VF714U	Approx. 2 hr. 40 min.
		BN-VF733U	Approx. 5 hr. 40 min.

* Provided

	PUSH
Battery pack	BATT.
Arrow	POWER/
	CHARGE
	lamp

4

5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

NOTES:

●It is recommended that only genuine JVC batteries are used in this camcorder. Using generic non-JVC batteries can cause damage to the internal charging circuitry.

●If the protective cap is attached to the battery pack, remove it first.

●During charging, the camcorder cannot be operated.

●Charging is not possible if the wrong type of battery is used.

●When charging the battery pack for the first time or after a long storage period, the POWER/ CHARGE lamp may not light. In this case, remove the battery pack from the camcorder, then try charging again.

●If the battery operation time remains extremely short even after having been fully charged, the battery is worn out and needs to be replaced.

Please purchase a new one.

●Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

●Using the optional AA-VF7 Battery Charger, you can charge the BN-VF707U/VF714U/VF733U battery pack without the camcorder.

●After 5 minutes has elapsed in Record-Standby mode with the cassette inserted, and no operation is performed (“ PAUSE” indicator may not appear), the camcorder will automatically turn off its power supplied from the AC adapter. In this case, the battery charge starts if the battery is attached to the camcorder.