A memory card cannot be played back.
• The Power Switch y is set to “ ” or “ 
”.
¥Set the Power Switch y to “PLAY” ( pg. 18).
• The VIDEO/DSC Switch 4 is set to “VIDEO”.
¥Set the VIDEO/DSC Switch 4 to “DSC”.
The LCD monitor image is distorted.
•During playback of the unrecorded portion,
Images on the LCD monitor are jittery.
•The speaker volume is too great.
¥Turn the speaker volume down ( pg. 14).
The charger indicator on the camcorder does
not light.
•The temperature of the battery is extremely high/low.
•Charging is difficult in places subject to extremely high/low temperatures.
¥To protect the battery, it is recommended to charge
it in places with a temperature of 10°C to 35°C (50°F to 95°F) ( pg. 41).
When the image is printed from the printer, a
black bar appears at the bottom of the screen.
•This is not a malfunction.
¥By recording with “DIS” activated ( pg. 29) this can be avoided.
There is no playback picture on the
connected TV.
•Since the analog input mode is engaged, the camcorder is in the
¥Set “S/AV INPUT” to “OFF” in the Menu Screen ( pg. 31).
When the camcorder is connected via the DV
connector, the camcorder does not operate.
•The DV cable was plugged/unplugged with power turned on.
¥Turn the camcorder’s power off and on again, then operate it.
Blocks of noise appear during playback, or there is no playback picture and the screen becomes blue.
¥Clean the video heads with an optional cleaning cassette ( pg. 42).
The LCD monitor, the viewfinder and the lens
have become dirty (ex. fingerprints).
¥Wipe them gently with soft cloth. Wiping strongly can cause damage ( pg. 43).
An unusual mark appears.
¥Check the section of the manual that explains LCD monitor/viewfinder indications ( pg. 48 – 51).
An error indication (E01, E02 or E06) appears.
•A malfunction of some kind has occurred. In this case the camcorder’s functions become unusable.
¥Remove the power supply (battery pack, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. Do not eject the cassette. This will cause damage to the tape.
An error indication (E03 or E04) appears.
•A malfunction of some kind has occurred. In this case the camcorder’s functions become unusable.
¥Eject the cassette once and
The memory card cannot be removed from
the camcorder.
¥Push in the memory card a few more times ( pg. 11).
EN
40 TROUBLESHOOTING
