JVC GR-D750U monitor, DC PLUG, TAPE END, LENS CAP, REFERENCES, SET DATE/TIME, TROUBLESHOOTING EN, UNIT IN SAFEGUARD MODE, UNIT IN SAFEGUARD MODE, EJECT AND REINSERT TAPE

		TROUBLESHOOTING EN 35
	Picture does not appear on the LCD	UNIT IN SAFEGUARD MODE
	monitor.	REMOVE AND REATTACH BATTERY OR
● The viewfinder is pulled out and “PRIORITY” is		DC PLUG
	set to “FINDER”.	Error indications 01, 02 or 06.
➜ Push the viewfinder back in or set “PRIORITY”		Remedy: Remove and reattach the power supply
	to “LCD”. ( pg. 8, 24)	or battery.
● The LCD monitor’s brightness setting is too
		UNIT IN SAFEGUARD MODE
	dark.
➜ Adjust the brightness of the LCD monitor.		EJECT AND REINSERT TAPE
	( pg. 14)	Error indications 03 or 04.
➜ If the monitor is tilted upward 180 degrees,
		Remedy: Eject the cassette and reinsert.
	open the monitor fully. ( pg. 8)
		In the above 2 error indications, the camcorder
	Aspect ratio is strange	turns off automatically. Eject the cassette once
If the aspect ratio of the video you are playing is		and re-insert it, then check if the indication clears.
		When it does, you can resume using the
strange, change the setting in “16:9 OUTPUT”.
		camcorder. If the indication remains, consult your
( pg. 24, 25)
		nearest JVC dealer.

Displays the battery remaining power.

Remaining power level

High Exhausted

As the battery power comes close to nil, the battery remaining power indicator blinks.

When the battery power is exhausted, power turns off automatically.

TAPE END

Appears when the tape ends during recording or playback.

LENS CAP

Appears for 5 seconds after power is turned on if the lens cap is attached or when it is dark.

SET DATE/TIME!

●Appears when the date/time is not set. (
pg. 14).

●The built-in clock battery has run out and the previously set date/time has been erased.

➜Consult your nearest JVC dealer for replacement.

REFERENCES