GETTING STARTED EN 13

Using The Battery Pack

Using AC Power

Perform steps 2 – 3 in “Charging The Battery Pack”.

Maximum continuous recording time

Battery pack

LCD monitor

Viewfinder on

on

 

 

 

 

 

BN-VF707U*

1 hr. 5 min.

1 hr. 25 min.

 

 

 

BN-VF714U

2 hr. 20 min.

3 hr.

 

 

 

BN-VF733U

5 hr. 25 min.

7 hr. 5 min.

 

 

 

* Provided

 

 

NOTES:

●Recording time is reduced significantly under the following conditions:

•Zoom or Record-Standby mode is engaged repeatedly.

•The LCD monitor is used repeatedly.

•The playback mode is engaged repeatedly.

●Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.

ATTENTION:

Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.

Data Battery System

You can check the remaining battery power and the recordable time.

1)Make sure the battery is attached and the Power Switch is set to “OFF”.

2)Open the LCD monitor fully.

3)Press BATT. DATA, and the battery status screen appears.

● It can be displayed on the viewfinder when the LCD monitor is closed.

● It is displayed for 5 seconds if the button is pressed and released quickly, and for 15 seconds if the button is pressed and hold for several seconds.

● If “COMMUNICATION ERROR” appears instead of the battery status even though you tried to press BATT. DATA several times, there may be a problem on the battery. In such a case, consult your nearest JVC dealer.

Perform steps 4 – 5 in “Charging The Battery Pack”.

NOTE:

The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

To resume the original function of the accurate battery power indication

If the battery power indication differs from the actual operating time, fully charge the battery, and then run it down. However this function may not turn back if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.