|
| VIDEO RECORDING EN 19 | |
Journalistic Shooting |
| ● When a tape is removed and | |
In some situations, |
| shooting. | |
| ● When shooting using a partially recorded tape. | ||
different shooting |
| ● When shooting on a blank portion located partway | |
angles may provide |
| through the tape. | |
more dramatic results. |
| ● When shooting again after shooting a scene then | |
Hold the camcorder in |
| opening/closing the cassette holder cover. | |
the desired position |
| NOTES: | |
and tilt the LCD |
| ● The time code cannot be reset. | |
monitor in the most |
| ||
| ● During | ||
convenient direction. It |
| ||
| code indication does not move smoothly. | ||
can rotate 270° (90° |
| ● The time code is displayed only when “TIME | |
downward, 180° |
| ||
upward). |
| Quick Review | |
Self Recording |
| ||
| Enables to check the end of the last recording. | ||
Open the LCD |
| ||
| 1) Press Q.REVIEW during the Recording- | ||
monitor and tilt it |
| Standby mode. | |
upward to 180° so |
| 2) Tape is rewound for about several seconds | |
that it faces forward, | Self | and played back automatically, then pauses in | |
point the lens toward | the | ||
Recording | |||
yourself and start | ● Distortion may occur at start of playback. This is | ||
| |||
recording. |
| normal. |
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
Display
Minutes
Seconds
Frames*
(25 frames = 1 second)
12 : 34 : 24
* Frames are not displayed during recording.
Recording From The Middle Of A Tape
1)Play back a tape or use Blank Search
( pg. 21) to find the spot at which you want to start recording, then engage the Still Playback mode. ( pg. 20)
2)Set the Power Switch to “A” or “M” while
pressing down the Lock Button located on the switch, then start recording.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform Recording From The Middle Of A Tape (See the right column.) in the following cases;
●When shooting again after playing back a recorded tape.
●When power shuts off during shooting.