22 EN VIDEO PLAYBACK |
|
| |
NOTES: | Playback Using The Remote | ||
● Set the video out select switch of the cable | Control |
| |
adapter as required: |
| ||
Y/C: When connecting to a TV or VCR which | The | ||
accepts Y/C signals and uses an | |||
CVBS: When connecting to a TV or VCR which | operate this camcorder from a distance as well | ||
does not accept Y/C signals and uses an audio/ | as the basic operations (Playback, Stop, Pause, | ||
video cable. | |||
● The | makes additional playback functions possible. | ||
the YTU94146A |
| ||
JVC Service Center described on the sheet | Installing The Battery |
| |
included in the package for details on its |
| ||
availability. Make sure to connect the end with | The remote control uses |
| |
a core filter to the camcorder. The core filter |
| ||
reduces interference. | one lithium battery | 2 | |
1 Make sure all units are turned off. | (CR2025). |
| |
1 Pull out the battery | 1 | ||
2 Connect the camcorder to a TV or VCR as | |||
shown in the illustration. | holder by pushing the lock | 13 | |
If using a VCR, go to step 3. | tab. |
| |
2 Insert the battery in the | Lock tab | ||
If not, go to step 4. | |||
3 Connect the VCR output to the TV input, | holder, and be sure to |
| |
have the “+” mark visible. |
| ||
referring to your VCR’s instruction manual. |
| ||
3 Slide the holder back in until you hear a click. | |||
4 Turn on the camcorder, the VCR and the TV. | |||
5 Set the VCR to its AUX input mode, and set | Beam Effective Area (indoor use) | ||
the TV to its VIDEO mode. | When using the remote |
| |
6 Start playback on the camcorder. ( pg. 20) |
| ||
control, be sure to point it |
| ||
To choose whether or not the following | at the remote sensor. |
| |
The transmitted beam’s |
| ||
displays appear on the connected TV |
| ||
approximate effective |
| ||
● Date/time |
| ||
distance for indoor use is |
| ||
Set “DATE/TIME” to “AUTO”, “ON” or “OFF”. |
| ||
( pg. 25, 30) | 5 m. | Remote sensor | |
|
| ||
Or, press DISPLAY on the remote control to turn | NOTE: | |
on/off the date indication. | ||
The transmitted beam may not be effective or may | ||
● Time code | ||
cause incorrect operation when the remote sensor | ||
Set “TIME CODE” to “ON” or “OFF”. | ||
is directly exposed to sunlight or powerful lighting. | ||
( pg. 25, 30) | ||
|
●Indications other than date/time and time code Set “ON SCREEN” to “OFF”, “LCD” or “LCD/TV”. ( pg. 25, 30)
NOTES:
●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 13)
●To monitor the picture and sound from the camcorder without inserting a tape, set the camcorder’s Power Switch to “A” or “M”, then set your TV to the appropriate input mode.
●Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.