| VIDEO RECORDING |
|
| EN 17 | |
Basic Recording |
| 1 Remove the lens cap. | ||
| 2 Press PUSH OPEN and open the LCD monitor | |||
NOTE: |
| fully, or pull out the viewfinder fully. | ||
| 3 Set the VIDEO/MEMORY Switch to “VIDEO”. | |||
Before continuing, perform the procedures listed | ||||
below: |
| 4 Set the Power Switch to “A” or “M” while | ||
| pressing down the Lock Button located on the | |||
| switch. | |||
Power/Charge Lamp |
| ● The power/charge lamp lights and the | ||
|
| camcorder enters the | ||
Power Zoom Lever |
|
| ||
|
| “PAUSE” is displayed. | ||
|
|
| ||
|
| 5 To start recording, press the Recording Start/Stop | ||
|
| Button. The tally lamp lights and “T REC” | ||
|
| appears on the display while recording is in | ||
|
| progress. | ||
|
| 6 To stop recording, press the Recording Start/Stop | ||
|
| Button again. The camcorder | ||
|
| |||
| Power Switch | NOTES: | ||
|
| ● The image will not appear simultaneously on the | ||
Lock Button |
| LCD monitor and the viewfinder. | ||
| ● If the | |||
Recording Start/Stop Button |
| |||
| 5 minutes, the camcorder’s power shuts off | |||
|
| |||
VIDEO/MEMORY Switch | automatically. To turn the camcorder on again, | |||
push back and pull out the viewfinder again or | ||||
|
| |||
|
| close and | ||
|
| ● LCD monitor/viewfinder indications: | ||
|
| • When power is supplied from a battery: the | ||
|
| “ | ||
|
| • When power is supplied from an AC outlet: the | ||
|
| “ | ” battery indicator does not appear. | |
|
| ● When a blank portion is left between recorded | ||
|
| scenes on the tape, the time code is interrupted | ||
Tally Lamp |
| and errors may occur when editing the tape. To | ||
| avoid this, refer to “Recording From The Middle | |||
(Lights while recording is in |
| |||
progress.) | PUSH OPEN Button | |||
● To turn the tally lamp or beep sounds off, pg. 31, 36.
● To record in LP (Long Play) mode, pg. 31, 34. ● For other notes, pg. 64.