EN 9

Automatic Demonstration

Automatic Demonstration takes place when “DEMO MODE” is set to “ON” (factory-preset).

MENU WheelLock ButtonPower SwitchSub Menu

SYSTEM

DEMO MODE – OFF

ON

Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “A” or “M” and no cassette is in the camcorder.

Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minute after that, the demonstration will resume.

“DEMO MODE” remains “ON” even if the camcorder power is turned off.

To cancel Automatic Demonstration

1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.

2Open the LCD monitor fully, or pull out the viewfinder fully.

3Press the MENU Wheel in. The Menu Screen appears.

4Rotate the MENU Wheel to select “s”, and press it. The SYSTEM Menu appears.

5Rotate the MENU Wheel to select “DEMO MODE”, and press it. The Sub Menu appears.

6Rotate the MENU Wheel to select “OFF”, and press it.

7Rotate the MENU Wheel to select “BRETURN”, and press it twice. The normal screen appears.

NOTE:

Detach the lens cap to see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.

AUTOMATIC DEMONSTRATION