8 EN
– – – – –
6
– – – – –
REC MODE
WIDE MODE OFF
64X
SP
ZOOM
GAIN UP
DIS
4
TO DATE / TIME MENU
TO SYSTEM MENU
END
OFF
AGC
0
FOCUS
EXPOSURE AUTO
OFF
OFF
AUTO
AUTO
W. BALANCE
4
FADER
/ WIPE
P. AE
/ EFFECT
END
TO MODE MENU
ON SCREEN OFF
ONDISPLAY
INDICATION ON
4
DATE / TIME DEC 25 ’ 99
PM 5 : 30
RETURN
DATE/TIME
A
M
P
L
A
Y
O
F
F
Date/Time Settings
The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
(Z pg. 31).
1
Set the Power Switch to “ ”. The power lamp lights
and the camcorder is turned on.
2
Press MENU/BRIGHT. The Recording Menu appears.
3
Move the highlight bar to “TO MODE MENU” by
rotating MENU/BRIGHT. Press it and the Mode Menu
appears.
4
Move the highlight bar to “TO DATE/TIME MENU”
by rotating MENU/BRIGHT. Press it and the Date/
Time Menu appears.
5
Move the highlight bar to “DATE/TIME” by rotating
MENU/BRIGHT. Press it and “month” is highlighted
and begins blinking.
Rotating MENU/BRIGHT, input the month. Press it.
Repeat to input the day, year, hour and minute.
Press MENU/BRIGHT twice when the highlight bar is
set to “RETURN” to exit.

Built-in Clock’s Rechargeable Lithium Battery

To store the date/time in memory, the clock’s rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock’s
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock’s rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:

Even if you select “DATE/TIME”, if the parameter is not

highlighted the camcorder’s internal clock continues to

operate. Once you move the highlight bar to the first date/

time parameter (month), the clock stops. When you finish

setting the minute and press MENU/BRIGHT, the date and

time begin operation from the date and time you just set.

GETTING STARTED
(cont.)
Power lamp
Mode Menu
Display
Date/Time Menu
MENU/BRIGHT
Dial
Power Switch
Recording Menu