52

EN

DETAILS

I T E M S N O T E S

❍Perform charging where the temperature is between 10°C and 35°C. 20°C to
25°C is the ideal temperature range for charging. If the environment is too
cold, charging may be incomplete.
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of
the battery pack.
❍To avoid interference with reception, do not use the AC Adapter near a radio.
❍Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
❍The following operation stops charging:
•Set the Power Switch to “PLAY”, “
AUTO
” or “
MANUAL
”.
•Disconnect the AC adapter from the camcorder.
•Unplug the AC adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
❍When you use the LCD monitor outdoors in direct sunlight, the LCD monitor
may be difficult to see. If this happens, use the viewfinder instead.
❍The cassette holder cannot be opened unless a power supply is attached.
❍There may be a delay after you open the cassette holder cover until the
cassette holder opens. Do not use force.
❍Once the cassette holder is closed, it recedes automatically. Wait until it
recedes completely before closing the cassette holder cover.
❍When the Recording Start/Stop button is pressed, it may take a few seconds
before actual recording starts. “ ” starts rotating when the camcorder
actually starts recording.
❍The time required to calculate and display the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape used.
❍“TAPE END” appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes. “TAPE END” also appears
when a cassette at its end is loaded.
➪RECORDING
(墌 pg. 15, 16)
➪Power
(墌 pg. 8)