JVC GR-DVL610SH, GR-DVL315A, GR-DVL810A, GR-DVL610A, GR-DVL710A EN47, Menu Screen Explanations

EN47

Menu Screen Explanations

	WIPE/FADER		Refer to “Fade/Wipe Effects” ( pg. 40, 41).
	PROGRAM AE		Refer to “Programme AE With Special Effects” ( pg. 38, 39).
	W.BALANCE		Refer to “White Balance Adjustment” and “Manual White Balance
			Operation” ( pg. 45).
	REC MODE		Allows you to set the video recording mode (SP or LP) depending on your
			preference ( pg. 13).
	SOUND	12 BIT	Enables video recording of stereo sound on four separate channels, and is
	MODE		recommended for use when performing audio dubbing. (Equivalent to the
			32 kHz mode of previous models)
		16 BIT	Enables video recording of stereo sound on two separate channels. (Equiva-
			lent to the 48 kHz mode of previous models)
	ZOOM	10X	When set to “10X” while using digital zoom, the zoom magnification will
			reset to 10X since digital zoom will be disengaged.
CAMERA		40X	Allows you to use the Digital Zoom. By digitally processing and magnifying
		500X	Allows you to use the Digital Zoom. By digitally processing and magnifying
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
			of 40X digital magnification.
			images, zooming is possible from 10X (the optical zoom limit), to a maximum
			of 500X digital magnification.
	SNAP MODE		Refer to “Basic Shooting (Snapshot)” ( pg. 26) or “Snapshot (For Video
			Recording)” ( pg. 42).
	GAIN UP	OFF	Allows you to shoot dark scenes with no picture brightness adjustment.
		AGC	The overall appearance may be grainy, but the image is bright.
		AUTO	The shutter speed is automatically adjusted (1/25 — 1/200 sec.). Shooting a
			subject in low or poor lighting at 1/25 sec. shutter speed provides a brighter
			image than in the AGC mode, but the subject’s movements are not smooth or
			natural. The overall appearance may be grainy. While the shutter speed is
			being automatically adjusted, “	” is displayed.
	DIS	OFF	To compensate for unstable images caused by camera-shake, particularly at
			high magnification.
			NOTES:
MANUAL			● Accurate stabilisation may not be possible if hand shake is excessive, or
			under the following conditions:
			•When shooting subjects with vertical or horizontal stripes.
		ON	•When shooting dark or dim subjects.
			•When shooting subjects with excessive backlighting.
			•When shooting scenes with movement in various directions.
			•When shooting scenes with low-contrast backgrounds.
			● Switch off this mode when recording with the camcorder on a tripod.
			● The “ ” indicator blinks or goes out if the Stabiliser cannot be used.

: Factory-preset

NOTES:

●The “ CAMERA” settings are effective when the Power Switch is set to both “ ” and “ ”.

●The “ MANUAL” settings are effective only when the Power Switch is set to “ ”.

CONTINUED ON NEXT PAGE