If using a Fade/Wipe at the end of the scene, press FADE/WIPE.
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.
•You cannot use a Picture Wipe/Dissolve at the end of the last scene.
•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).
Point the remote control at the camcorder’s remote sensor. Press PLAY (4) and then press R.A.EDIT ON/ OFF on the remote control.
The Random Assemble Editing Menu appears.
If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE on the remote control.
•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.
•You cannot use a Picture Wipe/Dissolve at the beginning of Programme 1.
At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.
At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.
| | I N | OUT MODE | Random Assemble |
| |
1 – – | – – : – – | ~ | | Editing Menu |
2 | | | ~ | |
| | | |
3 | | | ~ | | |
4 | | | ~ | | |
5 | | | ~ | | |
6 | | | ~ | | |
7 | | | ~ | | |
8 | | | ~ | | |
| T I ME | CODE | – – : – – | | |
| TOTAL | 00 : 00 | | |
Remote sensor
| | REW | | |
| FADE/WIPE | FF | 9 | If using Playback Special Effects, press EFFECT |
| PLAY |
| EFFECT | ( pg. 59). |
| |
| EDIT IN/OUT | R.A.EDIT | 10 | Repeat steps 6 through 9 to register additional scenes. |
| CANCEL | ON/OFF |
| •To change previously registered points, press |
| |
| | | | CANCEL on the remote control. The registered |
| | | | points disappear, one at a time, from the most |
| | | | recently registered point. |
| | | | •If you are not using Fade/Wipe or Programme AE |
| | | | with special effects, repeat steps 6 and 7 only. |
NOTES:
●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.
●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be cancelled and editing will not take place.
●If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version.
●Since time codes register time only as accurately as seconds, the time code total time may not match the total programme time exactly.
●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.
●If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.
●It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble Editing using a DV cable.
CONTINUED ON NEXT PAGE
