CAUTIONS | EN 75 |
When using the AC Adapter in areas other than the USA
The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.
USING HOUSEHOLD AC PLUG ADAPTER
In case of connecting the unit’s power cord to an AC wall outlet other than American National Standard C73 series type use an AC plug adapter, called a “Siemens Plug”, as shown.
For this AC plug adapter, consult your nearest JVC dealer.
Plug adapter 
Video Light
DANGER
The video light can become extremely hot. Do not touch it either while in operation or soon after turning it off, otherwise serious injury may result.
Do not place the camcorder into the
carrying case immediately after using the video light, since it remains extremely hot for some time.
When operating, keep a distance of about 30 cm
Do not use near flammable or explosive materials.
Do not place the camcorder in a cabinet or box while the video light is in operation.
When using the video light, if you wish to install the camcorder in a fixed position, attach it to a tripod, etc. Do not affix it directly to a surface such as a table top.
It is recommended that you consult your nearest JVC dealer for replacing the video light.
General Battery Precautions
If the remote control is not functioning even if it is being operated correctly, the batteries are exhausted. Replace them with fresh ones.
Use only the following batteries: AAA (R03) size x 2
Please make note of the following rules for battery use. When misused, the batteries can leak or explode.
1.When replacing batteries, refer to page 54.
2.Do not use any different size of batteries from those specified.
3.Be sure to install batteries in the correct direction.
4.Do not use rechargeable batteries.
5.Do not expose the batteries to excessive heat as they can leak or explode.
6.Do not dispose of the batteries in a fire.
7.Remove the batteries from the unit if it is to be stored for an extended period to avoid battery leakage which can cause malfunctions.
8.Do not recharge the provided batteries.
Battery Packs
The supplied battery pack is a
1. To avoid hazards . . . | Terminals | |
... do not burn. | ||
|
... do not
... do not modify or disassemble.
... do not expose the battery to temperatures exceeding 60°C (140°F), as this may cause the battery to overheat, explode or catch fire.
... use only specified chargers.
2.To prevent damage and prolong service life . . .
... do not subject to unnecessary shock.
... charge in an environment where temperatures
are within the tolerances shown in the chart below. This is a chemical reaction type battery— cooler temperatures impede chemical reaction, while warmer temperatures can prevent complete charging.
... store in a cool, dry place. Extended exposure to high temperatures will increase natural discharge and shorten service life.
... fully charge and then fully discharge the battery every 6 months when storing the battery pack over a long period time.
... remove from charger or powered unit when not in use, as some machines use current even when switched off.
NOTES:
●It is normal for the battery pack to be warm after charging, or after use.
Temperature Range Specifications
Charging ................ 10°C to 35°C (50°F to 95°F) Operation ............... 0°C to 40°C (32°F to 104°F) Storage ...................
●Recharging time is based on room temperature of 20°C (68°F).
●The lower the temperature, the longer recharging takes.
Cassettes
To properly use and store your cassettes, be sure to read the following cautions:
1.During use . . .
... make sure the cassette bears the Mini DV mark.
... be aware that recording onto prerecorded tapes automatically erases the previously recorded video and audio signals.
... make sure the cassette is positioned properly when inserting.
... do not load and unload the cassette repeatedly without allowing the tape to run at all. This slackens the tape and can result in damage.
... do not open the front tape cover. This exposes the tape to fingerprints and dust.
