JVC GR-DVM5 specifications Installing The Battery Pack, Open Battery Cover, Insert Charged Battery

EN9

Charging Environment

Perform charging where the temperature is between 10° and 30°C. 20° to 25°C is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.

Continuous Shooting

Continuous shooting is possible (See table below for recording time) under the following conditions:

•The temperature is approximately 20°C

However, . . .

•If the temperature is below 10°C, or

•If zoom or Record-Standby is engaged or LCD monitor is used repeatedly, continuous shooting capability is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.

Approximate recording time (unit: min)

No. of batteries to supply power		LCD monitor off/	LCD monitor on/
		Viewfinder on	Viewfinder off
Using one battery (BN-V607U) installed in the camcorder		60	50
Using one battery (BN-V615U) installed in the optional Battery		120	100
Holder (CU-V615U) attached to the camcorder
Using two batteries; one (BN-V607U) installed	BN-V607U x 2	120	100
in the camcorder and one (BN-V607U or
	BN-V607U &
BN-V615U) installed in the optional Battery		180	150
Holder (CU-V615U) attached to the camcorder	BN-V615U
Using a BN-V856U battery*		420	360

*The BN-V856U battery, as well as the AA-V80EK or AA-V80EA AC Power Adapter/Charger for charging it, is included in the optional VU-V856KIT Extended-Use Battery Pack Kit.

Installing The Battery Pack

The battery pack has not been charged at the factory. Before installing it in the camcorder, be sure to charge it with the AC Charger Station (☞ pg. 8). It is also possible to charge the battery pack installed in the camcorder (☞ pg. 55).

Open switch (BATTERY)

Battery cover

OPEN BATTERY COVER
1 Slide down the open switch.
INSERT CHARGED BATTERY
2 Insert the	mark end of the battery first.

Inserting the battery backwards will result in malfunction.

3 CLOSE BATTERY COVER

NOTES:

●To remove the battery pack, turn off the camcorder and open the battery cover so that the battery pack comes out halfway. Then pull out the battery pack.

●Be careful not to drop the battery pack.

Battery