EN

 

83

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SYMPTOM

 

POSSIBLE CAUSES

CORRECTIVE ACTION

 

 

 

44. The LCD monitor, the

44.

 

 

44. • Wipe them gently with soft

 

 

viewfinder and the lens have

 

 

————

cloth. Wiping strongly can

 

 

become dirty

 

 

cause damage (Z pg. 84).

 

 

 

 

 

 

 

 

(ex. fingerprints).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

45. An unusual mark appears.

45.

 

 

45. • Check the section of the

 

 

 

 

 

 

 

————

manual that explains LCD

 

 

 

 

 

 

monitor/viewfinder indica-

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

tions (Z pg. 88 – 92).

 

 

 

 

 

 

 

46. An error indication

46. • A malfunction of some kind

46. • Remove the power supply

 

 

 

(E01 — E06) appears.

 

has occurred. In this case the

(battery pack, etc.) and wait a

 

 

 

 

 

camcorder’s functions

few minutes for the indication

 

 

 

 

 

become unusable.

to clear. When it does, you

 

 

 

 

 

 

 

can resume using the

 

 

 

 

 

 

 

camcorder.

 

 

 

 

 

 

 

If the indication remains even

 

 

 

 

 

 

 

though you repeat the above

 

 

 

 

 

 

 

two or three times, please

 

 

 

 

 

 

 

consult your nearest JVC

 

 

 

 

 

 

 

dealer.

 

 

 

 

 

 

 

47. The charger indicator on the

47. • The temperature of the battery

47. • To protect the battery, it is

 

 

 

camcorder does not light.

 

is extremely high/low.

recommended to charge it in

 

 

 

 

 

• Charging is difficult in places

places with a temperature of

 

 

 

 

 

subject to extremely high/low

10°C to 35°C (50°F to 95°F)

 

 

 

 

 

temperatures.

(Z pg. 93).

 

 

 

 

 

 

 

48. Picture does not appear on

48. • The viewfinder is pulled out.

48. • Push the viewfinder back in.

 

 

 

the LCD monitor.

 

• The LCD monitor's brightness

• Adjust the brightness of the

 

 

 

 

 

setting is too dark.

LCD monitor (Z pg. 18).

 

 

 

 

 

 

 

• If the monitor is tilted upward

 

 

 

 

 

 

 

180 degrees, open the

 

 

 

 

 

 

 

monitor fully (Z pg. 18).

 

 

 

 

 

 

 

49. When the image is printed

49. • This is not a malfunction.

49. • By recording with “DIS”

 

 

 

from the printer, a black bar

 

 

 

activated (Z pg. 39) this can

 

 

appears at the bottom of the

 

 

 

be avoided.

 

 

screen.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

50. When the camcorder is

50. • The DV cable was plugged/

50. • Turn the camcorder’s power

 

 

 

connected via the DV

 

unplugged with power turned

off and on again, then operate

 

 

 

 

 

 

connector, the camcorder

 

on.

it.

 

 

 

does not operate.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

51. The memory card cannot be

51.

 

 

51. • Push in the memory card a

 

 

 

removed from the

 

 

————

few more times (Z pg. 14).

 

 

camcorder.