EN23

Menu Screen Explanations

FADER/WIPE

P.AE/EFFECT

W.BALANCE

 

REC MODE

 

SOUND

 

 

12 BIT

 

MODE

 

 

 

 

 

 

16 BIT

 

ZOOM

10X

 

 

 

 

 

40X

 

 

 

 

 

200X

MENU

MODE

 

FULL

 

SNAP

CAMERA

 

PIN-UP

GAIN UP

OFF

 

 

 

AGC

 

 

AUTO

 

 

BEEP/

ON: MEL.

TALLY

 

 

ON:BEEP

 

OFF

ID NUMBER

: Factory-preset

Refer to “Fade/Wipe Effects” ( pg. 28, 29).

Refer to “Programme AE With Special Effects” ( pg. 30, 31).

Refer to “White Balance Adjustment” and “Manual White Balance Operation” ( pg. 33).

Allows you to set the recording mode (SP or LP) depending on your preference ( pg. 11).

Enables recording of stereo sound on four separate channels, and is recommended for use when performing audio dubbing. (Equivalent to the 32 kHz mode of previous models)

Enables recording of stereo sound on two separate channels. (Equivalent to the 48 kHz mode of previous models)

When set to “10X” while using digital zoom, the zoom magnification will reset to 10X since digital zoom will be disengaged.

Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 10X (the optical zoom limit), to a maximum of 40X digital magnification.

Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 10X (the optical zoom limit), to a maximum of 200X digital magnification.

Refer to “Snapshot” ( pg. 16).

Allows you to shoot dark scenes with no picture brightness adjustment.

The overall appearance may be grainy, but the image is bright.

The shutter speed is automatically adjusted (1/25 — 1/200 sec.). Shooting a subject in low or poor lighting at 1/25 sec. shutter speed provides a brighter image than in the AGC mode, but the subject’s movements are not smooth or natural. The overall appearance may be grainy. When shooting a subject in

low lighting in this mode, “” is displayed.

The tally lamp comes on to signal the start of recording. Instead of a beep, a melody sounds when any operation is performed. It also activates the shutter sound effect ( pg. 16).

The tally lamp comes on to signal the start of recording.

The beep sounds when the power is turned on or off, and at the beginning and end of recording. Also to activate the shutter sound effect ( pg. 16).

The tally lamp remains off at all times.

Even though not heard while shooting, shutter sound is recorded on the tape.

This number is necessary when connecting the camcorder to a device such as a computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.

NOTE:

The “ CAMERA MENU” settings are effective when the Operation Switch is set to both “” and “”.

CONTINUED ON NEXT PAGE