44 EN

POWER Switch

Lock Button

Open the connector cover.

To DV

IN/OUT

Core filter

DV cable (optional)

Core filter

DUBBING (cont.)Dubbing To A Video Unit Equipped With A DV Connector (Digital Dubbing)

It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

[To use this camcorder as a player]

1 Make sure the camcorder’s power is off.

2 Connect the camcorder to your video unit equipped with a DV connector using a DV cable as shown in the illustration.

3 Set the camcorder’s POWER Switch to “” while pressing down the Lock Button located on the switch. Press 4 to play back the source tape.

4 While watching the playback on the monitor, engage the DV connector-equipped video unit’s record mode from the spot on the source tape you want to begin recording.

To DV IN

Video unit equipped with DV connector

NOTES:

● It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the battery pack

( pg. 7).

● If the remote control is used when both the player and

recorder are JVC video units, both units will perform the

same operation. To prevent this from happening, press

the buttons on both units.

● For Digital Dubbing, this camcorder can be connected

only to one device at a time.

● If a blank portion or disturbed image is played back on

the player during dubbing, the dubbing may stop so that

an unusual image is not dubbed.

● Even though the DV cable is connected correctly,

sometimes the image may not appear in step 3. If this

occurs, turn off the power and make connections again.

PLAY (4) STOP (5)

● If “Playback Zoom” ( pg. 48), “Playback Special

Effects” ( pg. 49) or “Snapshot” is attempted during

playback, only the original playback image recorded on

the tape is output from the DV OUT connector.

● When using a DV cable, be sure to use the optional JVC

VC-VDV204U DV cable.