
68
EN





































TROUBLESHOOTING

(cont.)

When the System Select Switch is set to “VIDEO”:
SYMPTOM |
| POSSIBLE CAUSE(S) |
RECORDING |
|
|
Recording cannot be performed. |
| ● Make sure the Erase Protection tab is in the position that |
|
| allows recording. If not, slide the tab. Some cassettes have |
|
| removable tabs. If the tab has been removed, cover the |
|
| hole with adhesive tape (☞ pg. 13). |
|
| ● If the System Select Switch is set to “D.S.C.”, it is not |
|
| possible to record onto the tape. Change the Switch |
|
| position to “VIDEO” (☞ pg. 16). |
|
|
|
Animation or |
| ● Before recording in the Animation mode at the very |
available. |
| beginning of a tape, set the camcorder to the Recording |
|
| mode for about 5 seconds, so that the tape runs smoothly. |
|
| Using the |
|
| begin an animated programme (☞ pg. 43, 59). |
|
|
|
Recording does not start. |
| ● The camcorder Power Switch has not been set to |
|
| “CAMERA” (“AUTO“ or “PRO.“) (☞ pg. 16). |
|
|
|
PLAYBACK |
|
|
The tape is running, but there is no |
| ● The TV has not been set to its VIDEO mode or channel. |
playback picture. |
| ● If A/V connection is used, the TV’s VIDEO/TV Switch has |
|
| not been set to VIDEO. |
|
|
|
Playback cannot be performed. |
| ● If the System Select Switch is set to “D.S.C.”, it is not |
|
| possible to play back a tape. Change the Switch position to |
|
| “VIDEO” (☞ pg. 44). |
|
|
|
Playback picture is blurred or |
| ● The video heads are dirty or worn out. Consult your nearest |
interrupted. |
| JVC dealer for head cleaning or replacement. |
|
|
|
The counter indication is blurred |
| ● This is normal. |
during Still playback. |
|
|
|
|
|
TAPE TRANSPORT |
|
|
The tape stops during |
| ● The Counter Memory Function has been activated |
rewind. |
| (☞ pg. 46). |
|
|
|
Rewinding or |
| ● The tape is already fully wound on one reel or the other. |
be performed. |
|
|
|
|
|
OTHER |
|
|
The picture is blurred in the Quick |
| ● This is normal while recording in the LP mode. Some noise |
Review or Retake mode. |
| may be present while recording in the SP mode (☞ pg. 12). |
|
|
|
The date and time displays |
| ● If you remove the power source from the camcorder while |
disappear. |
| the power is on, all settings and selections are erased. Make |
|
| sure to turn the camcorder’s power off before disconnecting |
|
| the power source. |
|
|
|
The wrong date and time are |
| ● If you have not performed Date/Time Setting (☞ pg. 11), |
displayed/recorded. |
| the date and time are not displayed/recorded correctly. Be |
|
| sure that Date/Time setting is carried out. |
The tape will not eject.
●The battery pack is running low.
●If the LCD monitor is not open over 60 degrees, EJECT switch does not function.