JVC GR-SXM335 EN35, EJECT, ➪ TBC, ” or “, ” or “, ➪ Power, Settings, I T E M S, N O T E S, (
pg. 6), (
pg. 9), incomplete, (Time Base, Corrector), (
pg. 31), ➪ Date/Time

DETAILS				EN35
I T E M S	N O T E S
➪ Power	❍ Perform charging where the temperature is between 10°C and 35°C
( pg. 6)	(50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature
	range for charging. If the environment is too cold, charging may be
	incomplete.
	❍ Charging times are for a fully discharged battery pack.
	❍ Charging time varies according to the ambient temperature and the
	status of the battery pack.
	❍ To avoid interference with reception, do not use the AC Adapter
	near a radio.
	❍ Since the AC Adapter processes electricity internally, it becomes
	warm during use. Be sure to use it only in well-ventilated areas.
	❍ The following operation stops charging or discharging:
	•Set the Power Switch to “	”, “	” or “	”.
	•Disconnect the AC Adapter from the camcorder.
	•Unplug the AC Adapter’s power cord from the AC outlet.
	•Detach the battery from the camcorder.
➪ Date/Time	❍ The date/time cannot be stored in memory if the built-in clock
Settings	battery runs out. Consult an authorized JVC dealer for replacement,
( pg. 9)	or set the date/time as necessary before you start shooting.
➪ Recording	❍ When the Power Switch is set to “		” or “	” and the LCD
( pg. 14, 15)	monitor is opened at an angle of 60 degrees or more, the LCD
	monitor switches on and the viewfinder switches off automatically
	to save power.
	❍ The cassette holder cannot be opened unless a power supply is attached.
	❍ There may be a delay after you slide EJECT until the cassette holder
	opens. Do not use force.
	❍ The time required to calculate the remaining tape length, and the
	accuracy of the calculation, may vary according to the type of tape used.
	❍ The tape remaining time indicator is correct only if the correct tape
	length has been selected ( pg. 12).
	❍ “TAPE END” appears when the tape reaches its end, and the power
	goes off automatically if left in this condition for 5 minutes.
	“TAPE END” also appears when a cassette whose tape is already at
	its end is loaded.
	❍ If the Recording Start/Stop button is pressed after the Record-
	Standby mode has continued for over 5 minutes, recording may not
	start immediately.
	❍ While shooting, sound is not heard from the speaker.
➪ TBC	❍ The “TBC” indicator turns green (gray with a camcorder equipped
(Time Base	with a black/white viewfinder) while TBC is working.
Corrector)	❍ TBC does not work during still playback and shuttle search.
( pg. 31)	❍ The “TBC” indicator turns white while TBC is not operative.
	❍ It may take a few seconds before TBC actually starts working.
	❍ The picture may be distorted if the TBC mode is activated or
	deactivated at the edit-in/-out points or when normal playback
	resumes after still playback or shuttle search.
	❍ If the playback picture is distorted when TBC is set to on, turn off TBC.