JVC GZR10AUS manual Charging the Battery, Adapter Cable AC Adapter Provided To AC Outlet, To 240

Charging the Battery

A battery is built into the camcorder.

Charging Lamp			B
A
		Adapter Cable		AC Adapter
		(Provided)		(Provided)
					C
	D			To AC Outlet
				(110 V to 240 V)

1 Open the terminal cover (p. 7)

2 Connect adapter cable to AC adapter.

3 Plug in the AC adapter to AC outlet (110 V to 240 V).

4 Connect the other side to USB socket on the unit.

CAUTION

0At the time of purchase or in case of the battery is not used for a long period of time, the charging time will be longer than usual. The camera does not turn on if the remaining battery power is low. In this case, charge the battery for more than 20 minutes before turning on the power.

0Charging time: Approx. 4 h 40 m (when charging at 25°C (77°F))

0The battery cannot be charged outside the room temperature range of 10°C to 35°C (50°F to 95°F). The CHARGE lamp does not light up when the battery is not being charged. If the temperature increases or decreases during charging, the CHARGE lamp will blink slowly and charging will stop. In this case, remove the AC adapter, press the Reset button and wait until the room temperature is within the above stated range before charging again.

0You can record or play back videos during charging. (However, the charging time will be longer than usual. In addition, the remaining battery power may decrease according to conditions.) If the internal temperature rises when using the unit, stop the charging temporarily. (The CHARGE lamp goes off.)

0If malfunctions (such as overvoltage) occur, charging will stop. In this case, the CHARGE lamp blinks quickly as a notification.

0When the recording time becomes extremely short even when the battery is fully charged, the battery needs to be replaced. For details on replacing the built-in battery (subject to a fee), consult the nearest JVC service center.

0For details on other charging methods, please refer to the “Detailed User Guide”.

8EN