EN 17
D Adjusting tracking condition
—Tracking Adjustments
Automatic tracking adjustment
This VCR automatically adjusts the tracking condition. Whenever you insert a tape and start playback, automatic tracking starts working and continuously analyzes the signal to enable optimum picture quality during playback.
Manual tracking adjustment
If automatic tracking cannot eliminate noises well during playback, use the manual tracking following the procedures below.
You can also use the manual tracking during slow motion playback ( pg. 23).
1 Activate manual tracking
Press CH 5 and ° on the front panel at the same time during playback.
2 Eliminate the noises on the TV screen.
Press CH 5 and ° (or CH + and – on the Remote). Press it briefly for a fine adjustment, or press and hold for coarse adjustment. Watch the screen and continue adjustment until optimum picture and sound quality are achieved.
3 Reactivate automatic tracking
Press CH 5 and ° on the front panel at the same time. The automatic tracking becomes active again. “AUTO PICTURE” will momentarily flash on the TV.
E Automatic operations after
rewinding — Next Function Memory
The Next Function Memory “tells” the VCR what to do after rewinding is complete.
Ensure that the VCR is in stop mode.
a– For Automatic Playback Start
Press REW ( 1 ), then press PLAY ( 3 ) within 2 seconds.
b– For Automatic Power Off
Press REW ( 1 ), then press POWER within 2 seconds.
c– For Automatic Timer Standby
Press REW ( 1 ), then press TIMER within 2 seconds.
NOTE:
It is not possible to select the Automatic Timer Standby function if the cassette’s record safety tab is removed.
