JVC HR-A47U manual Auto Picture, Picture Control, Auto Timer, Superimpose

		EN 29
		* The default setting is bold in the table below.
AUTO PICTURE		When this function is set to “ON”, this VCR checks the condition of the
ON		tape in use during playback, and compensates to provide the highest-
		possible playback pictures.
OFF
PICTURE CONTROL		This function helps you to adjust the playback picture quality according
AUTO (NORM): Normally select		to your preference.
	this. Picture quality is	NOTES:
	adjusted automatically.
	When “AUTO PICTURE” is	When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not
	“OFF”, “NORM” will appear	change until you select again.
	instead of “AUTO”.	Select "EDIT" when you are dubbing tapes ( pg. 31). After you finish dubbing
EDIT:	Minimizes picture	the tapes, select “AUTO” (“NORM” when “AUTO PICTURE” is “OFF”.)
	degradation during editing
	(recording and playback).
SOFT:	Reduces image
	coarseness when viewing
	overplayed tapes
	containing much noise.
SHARP: Clearer, sharper-edged
	picture when viewing
	images with much flat,
	same-colored surfaces
	such as cartoons.
AUTO TIMER		When this function is set to “ON”:
ON		The timer recording standby mode is automatically engaged when the
		VCR is turned off. It is temporarily canceled when the VCR is turned
OFF
		on. You do not have to press TIMER to engage or disengage the timer
		recording standby mode.
		When this function is set to “OFF”:
		You have to press TIMER to engage or disengage the timer recording
		standby mode.
SUPERIMPOSE		When this function is set to “ON”, various VCR status information (on-
ON		screen display) appears on the screen.
OFF		NOTES:
		When you use this VCR as the playback VCR for editing a tape, be sure to set
		this function to “OFF”; otherwise, the VCR status information (on-screen
		display) will be recorded on the edited tape.
		If you select a channel on which no signal is received, the channel number is
		displayed regardless of this function setting.