JVC HR-E249E specifications Enter Showview Number, Confirm Channel Position Number, Close Menu

	ENTER SHOWVIEW
	NUMBER
	Press OK, and a cursor		GUIDE PROG SET
	appears above “GUIDE
4 PROG”. Then, using the			1 2 3 4 5
	NUMBER keys, input the		GUIDE PROG	TV PROG
	SHOWVIEW number (found	1		1
	in most TV listings) of a
	program scheduled to be
	broadcast on each station
		[0-9] =
	on the list from step 1,	[MENU] : EXIT
starting at the top. If you		When entering a SHOWVIEW
enter the wrong number,
		number for ZDF
press CANCEL to backspace
and input the correct number.
	CONFIRM CHANNEL
	POSITION NUMBER
	Press OK and the display

EN11

When Using A Satellite

Tuner

		Satellite Antenna			Aerial or Cable
Ex. 1			Ex. 2
	Satellite			Satellite
				Tuner and
	Tuner
				Decoder

4		GUIDE PROG SET
under “TV PROG” begins
5 blinking.
If the blinking number	GUIDE PROG		TV PROG
under “TV PROG” agrees
		2	2
with the channel
position . . .
. . . press OK.	[5°] =
If the numbers do not	[MENU] : EXIT
agree . . .
. . . input the channel position using PUSH JOG%Þ or
the NUMBER keys, then press OK.

● If you input the SHOWVIEW number of a program that

has already aired, “ERROR” appears on screen for a

AV2 IN/DECODER

TV Receiver

Preparation

Rear View

few seconds. Input the correct SHOWVIEW number.

● Repeat steps 4 and 5 as necessary.

CLOSE MENU

6 Press MENU and selection is complete.

If you already know the Guide Program number for a station . . .

1– After step 3, press PUSH JOG %.

●The GUIDE PROG number begins blinking.

2– Enter the Guide Program number using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG %.

●The TV PROG number begins blinking.

3– Enter the channel position using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG% .

●Repeat 2 and 3 as necessary. 4– Press MENU.

1– Connect the satellite tuner to the AV2 IN/DECODER connector on the rear of your recorder.

2– Set "AV2 SELECT" to "AV2" (☞ pg. 30).

To Record Satellite Broadcasts . . .

1– Select the appropriate channel on the satellite tuner.

2– Press NUMBER key "0" to set your recorder's input mode to "AUX2".

3– Start recording (☞ pg. 18, steps 3 – 5).

To Record Satellite Broadcasts Using SHOWVIEW Timer Recording . . .

1– Perform Guide Program Number setting.

●In step 5 in the left column, press NUMBER key "0" to set "TV PROG" to "AUX2".

2– Perform SHOWVIEW Timer Recording (☞ pg. 24).

To Record Satellite Broadcasts Using Regular Timer Recording . . .

1– In step 6 on page 27, press TV PROG. +/– to set the channel position to "AUX2".

NOTE:

When timer-recording a satellite programme, first set the satellite tuner to the appropriate channel before the selected programme begins and then set the satellite tuner's timer. If your satellite tuner does not have a timer, leave it switched on.