JVC HR-E249E Timer Recording, EN Timer RECORDINGcont, When Using The Illumi-Guide Feature

24ENTIMERRECORDING(cont.)

SHOWVIEW

Timer

Recording

Before performing SHOWVIEW timer recording:

●Be sure to read "SHOWVIEW Setup" (☞ pg. 10).

●Insert a cassette with the safety tab in place. The recorder will come on automatically.

●Turn on the TV and select the VIDEO channel (or AV mode).

6		5/8
q	1	Á

TIMER
		2
	1	2	3
NUMBER	4	5	6 ADD TIME
:PDC/VPS	7	8	9	WEEKLY
		0		TIMER
CANCEL				4
		DAILY		TV/SAT./VCR
				.CHECK
				PROG
PROG./MENU	1	3		OK

ILLUMI GUIDE

During SHOWVIEW and regular timer programming, the Illumi- Guide feature tells you which button on the remote control must be pressed next by lighting it up. To use this feature, with the TV/SAT./VCR switch set to "VCR", press ILLUMI GUIDE before performing step 1. (PROG., REW, PLAY, FF light up at this time.)

If you aren't going to use the Illumi-Guide feature, go directly to step 1.

ACCESS TIMER PROGRAM- MING SCREEN

1	Press PROG.
		TIMER PROGRAMMING
		[0 – 9] : SHOWVIEW
		[+/–] : EXPRESS PROGRAMMING
		[MENU] : MAIN MENU

The front display panel looks like this:

●If you are using the Illumi-Guide feature, the following buttons will light up: NUMBER keys (0–9),START +/–,STOP +/–,DATE +/–,TV PROG. +/–,MENU and

CANCEL.

ENTER SHOWVIEW

NUMBER

Press the NUMBER keys to	SHOWVIEW
enter the SHOWVIEW
2 number of a programme	1 2 3 4 5 6 7 8
you wish to record.

●If you make a mistake, press CANCEL to

backspace and then	[0 – 9] =
input the correct number.	[CANCEL] : DELETE
	[MENU] : EXIT

The SHOWVIEW number

you enter appears on the front display panel:

The display panel can only show 4 digits at a time.

●If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: NUMBER keys (0– 9), CANCEL and MENU.

When Using The Illumi-Guide Feature

●Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press MENU and re-perform the timer programming procedure from the beginning.

●If for some reason the remote control's signal is not received by the video recorder, press MENU and re-perform the timer programming procedure from the beginning.