Tune The TV To Your Video Recorder, SET TV Channel

INSTALLINGYOURNEWRECORDER (cont.)

Tune The TV

To Your Video

Recorder

q 5/8 6

OPERATE

Back of VCR

The video recorder sends picture and sound signals via the RF connecting cable to your TV on UHF channel 36.

	1		TURN ON THE RECORDER
	1		Press OPERATE.
	2		SELECT OUTPUT MODE
	2		Set the TEST switch on the back of the recorder to ON.
	3		SET TV CHANNEL
			Set your TV to the video channel (UHF channel 36).
			Two white bars appear on screen vertically.
			● Tune the TV until the bars are as clear as they can be.
			● Tune the TV until the bars are as clear as they can be.
			● Your TV should be set to the channel designated for
			use with a video recorder, or to a spare channel if
			there is not a specified video channel on your TV.

	4		RESET OUTPUT MODE
	4		Return the TEST switch to OFF.

VIDEO

TEST

ON OFF

NOTES:

●If CH36 is occupied by a local station, adjust the RF output channel adjustment screw to use another channel between CH32 and CH40 instead.

●If some interference noise is continually seen on the screen, consult your JVC dealer.

Page 4

Image 4

JVC HR-J231SA Tune The TV To Your Video Recorder, Select Output Mode, SET TV Channel, Reset Output Mode, Back of VCR

Contents

HR-J231SA Safety Precautions Do not place the recorder Check Contents Basic ConnectionsSituate Recorder Connect Recorder to Mains Select Output Mode Reset Output ModeTune The TV To Your Video Recorder SET TV Channel On-Screen Displays Access Channel SET Mode Select ScreenSelect Mode Select Band Select Position Store ChannelSelect Channel Return to Normal Screen Perform Tuning Fine-Tuning ChannelsReturn to Normal Already Stored Clock Set SET TimeSET Date SET Year Basic Playback Load a CassettePoint Start Playback Playback Features Activate Instant Review Activate IntelligentPicture Activate Repeat Playback Activate Counter SET Counter MemoryMemory Basic Recording Recording Features ShowView Setup Access Channel SET Mode Select Screen Input Guide Prog Number Press OK Guide ProgNumber starts blinking Repeat steps 3 5 as necessary ShowView Timer Programming Access ShowviewEngage Timer Mode Enter Showview Timer Regular Timer Programming Enter Programme Stop Time Timer Mode TimerEngage RECORDER’S Select Programme SET Recording DECK’S Input Mode Edit To Or From Another Video RecorderMake Connections Start Source Player SET RECORDER’S Input Mode Edit From a CamcorderStart Camcorder Start Recorder Troubleshooting Clear Tape-to-tape editing is not possible Timer againResume recording Questions and Answers Maximum recording time UHF channels 36 AdjustableRotary two-head helical scan Index Display Panel Installing Batteries How To UseButtons shown in white can also be used to operate JVC TVs Operating JVC TVs Memo HR-J231SA

JVC HR-J231SA Tune The TV To Your Video Recorder, Select Output Mode, SET TV Channel, Back of VCR

Models: HR-J231SA

Tune The TV

To Your Video

Recorder

Back of VCR

SELECT OUTPUT MODE

SET TV CHANNEL

Two white bars appear on screen vertically.

RESET OUTPUT MODE

VIDEO