JVC HR-J295EK manual Set channel on TV, Access Video Channel Set Mode, Set Video Channel

14initial settings

before you start

The power cord must be plugged in and connected to the VCR

The VCR must be turned on

The Remote Control must have batteries inserted

The TV set must be turned on

Video Channel Set

The VCR can send picture signals to the TV set in one of two ways; RF (ordinary cable included with this VCR) and AV (via a 21-pin SCART cable available from TV and Hi-Fi dealers). Depending upon which method you use, the VCR must have the correct method set up in order to work. The Video Channel is originally set to channel 22 but if for any reason this fails to happen, the instructions below describe how to set the Video Channel manually.

Set channel on TV

Select the vacant position 22 on you TV.

Access Video Channel Set Mode

Press obutton on the Remote Control to enter the standby mode. Press and hold PR+ or Ð on the VCR for more than 3 seconds.

Set Video Channel

if you are using both the rf cable and

21-pin SCART cable for connection Press PR+ or Ð to set the Video Channel to OFF.

if you are using only the rf cable for

connection Press PR+ or Ð to set the Video	RF CHANNEL : 22
Channel to a vacant position between 22 and 68
which is not occupied by any station in your area
(refer to station list on pageÊ22).

Exit Video Channel Set Mode

Press o.

To view pictures from your VCR you must now set your TV to either the Video Channel or to AV mode, depending upon your choice above.