JVC HR-J435EK specifications Possible Cause, Timer again

								41
3.	Tape-to-tape editing is not possible.			● The source (another video recorder,		Confirm that the source is properly
				camcorder) has not been properly		connected.
				connected.
				● All necessary power switches have		Confirm that all units’ power switches
				not been turned on.		are turned on.
				● The input mode is not correct.		Set the input mode to “AU”.
4.	Camcorder recording is not			● The camcorder has not been		Confirm that the camcorder is
	possible.			properly connected.		properly connected.
				● The input mode is not correct.		Set the input mode to “AU”.
TIMER RECORDING
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Timer recording won’t work.			● The clock and/or the timer have		Re-perform the clock and/or timer
				been set incorrectly.		settings.
				● The timer is not engaged.		Press TIMER and confirm that “ä“ is
						displayed on the display panel.
2.	On-screen timer programming is			● Timer recording is in progress.		Timer programming can’t be
	not possible.					performed while a timer recording is
						in progress. Wait until it finishes.
3.	“ä“ and “]“ on the display			● The timer is engaged but there’s no		Load a cassette with the Record
	panel won’t stop blinking.			cassette loaded.		Safety tab intact, or cover the hole
						using adhesive tape.
4.	The cassette is automatically			● The loaded cassette has had its		Remove the cassette and cover the
	ejected, and “ä“ and “]“ on the			Record Safety tab removed.		hole with adhesive tape, or insert a
	display panel won’t stop blinking.					cassette with the Record Safety tab
						intact.
5.	“ä“ blinks for 10 seconds and the			● TIMER has been pressed when there		Check the programmed data and re-
	Timer mode is disengaged.			are no programs in memory, or the		program as necessary, then press
				timer record information has been		TIMER again.
				programmed incorrectly.
6.	The cassette is automatically			● The end of the tape was reached		The programme may not have been
	ejected, the power shuts off and			during timer recording.		recorded in its entirety. Next time
	“ä“ and “]“ won’t stop					make sure you have enough time on
	blinking.					the tape to record the entire
						programme.
7.	Video Plus+ does not timer-record			● The recorder’s preset positions have		Refer to "Guide Channel Set" and
	properly.			been set incorrectly.		re-perform the procedure (☞ pg. 26).
OTHER PROBLEMS
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Whistling or howling is heard from		● The camcorder’s microphone is too			Position the camcorder so its
	the TV during camcorder record-			close to the TV.		microphone is away from the TV.
	ing.		● The TV’s volume is too high.			Turn the TV’s volume down.
2.	When scanning presets, some of		● Those presets have been designated			If you need the skipped presets,
	them are skipped over.			to be skipped.		restore them (☞ pg. 34).
3.	The preset cannot be changed.		● Recording is in progress.			Press PAUSE to pause the recording,
						change presets, then press PLAY to
						resume recording.
4.	The remote control won’t operate		● The TV/VCR switch is in the wrong			Set the switch to TV.
	my TV.			position.