JVC HR-J455EK, HR-J255ES, HR-J255EK, HR-J256EK setup guide Uick SET UP Guide

AUTO SET

PLEASE WAIT

8

QUICKSETUPGUIDE (cont.)

STEP

4

AUTO SET UP

SET THE TUNER CHANNELS, CLOCK AND GUIDE PROGRAM NUMBERS

The Auto Set Up function sets the tuner channels, clock and Video Plus+ assigned Guide Program numbers automatically the first

time the button on the recorder or on the remote is pressed to turn on the recorder after the mains power cord has been plugged into a mains outlet.

Before performing the following procedure, make sure that:

■the TV aerial cable is connected to the recorder.

■the mains power cord is plugged into the mains outlet.

		1
1	2	3
		2
4	5	6
7	8	9
	0	4
1	?

Press .

"Auto" appears on the display panel and blinks; do NOT press any button on the recorder or remote control until the display panel shows either the current time or "(PR)1" or "– – :– –". (Refer to box on page 9.) Auto Set Up usually takes about 4 – 12 minutes; the duration varies by area.

●Auto channel set function takes place first; it assigns automati- cally all receivable stations in your area.

●Auto clock set function sets the clock automatically.

●During auto channel set, the recorder recognizes each station name of the detected stations and stores them in the recorder's memory, then automatically sets the Video Plus+ assigned Guide Program number for those stations according to the broadcast area.

●If the TV power is on and its video channel or AV mode is selected

during Auto Set Up, the AUTO SET screen will appear.

0 + + +

●If there is power cut or if you

press	or MENU while	[MENU] : EXIT
Auto Set Up is in progress,		Beginning	End
Auto Set Up will be interrupted;
be sure to turn off the recorder power once and press			to turn
the power back on in order to re-start Auto Set Up.

IMPORTANT

■In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, when you timer-record a TV programme using Video Plus+, the recorder will record a TV programme of a different station. When programming the timer using Video Plus+, be sure to check that the preset position corresponding to the broadcasting station you wish to record has been selected (☞ pg. 14, "Video Plus+ Timer Programming").

■Your video recorder memorizes all detected stations even if reception of some of them is poor. In these cases picture quality may be poor. To delete those stations which have an unacceptable picture ☞ "Delete A Channel" on page 33.

■If any of the above problems occur, refer to pages 32 – 34 to input station names (☞ "Set Stations") or delete unnecessary stations (☞ "Delete A Channel"). You can also change station preset positions (☞ "Change Station Preset Position").

ATTENTION

Once you have performed Auto Set Up, all the stored stations and their Guide Program numbers remain in the recorder's memory and the recorder will not perform Auto Set Up again. If there is a power cut and the recorder's memory backup expires you only need to reset the clock. (☞ pg. 37)

If you have moved to a different area, perform each setting as required.

■Tuner setting ☞ pg. 30

■Clock setting ☞ pg. 37

If a new station begins broadcasting in your area, perform tuner setting (☞ pg. 30).