26
EN
EDITING
Edit To Or
From Another
Video
Recorder
You can use your video recorder as the source player or the recording deck.
MAKE CONNECTIONS
1 Connect the player's AUDIO/VIDEO OUT connector to the recorder's AUDIO/VIDEO IN connector.
SET RECORDING DECK'S INPUT MODE
2 Set to AUX. With this video recorder, press NUMBER key "0" and/or TV PROG to select depending on the connector being used —
SELECT "EDIT" FOR PICTURE CONTROL SET MODE
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
NUMBER "0" | 0 |
|
|
|
2
4
TV PROG
3 Follow the "Picture Control" section on page 15, then select "EDIT."
NOTE:
When you select "EDIT" to dub tapes, be sure to select "AUTO" (or "NORM" when the B.E.S.T. function is set to "OFF") after you finish dubbing the tapes.
START SOURCE PLAYER
1
4 Engage its Play mode.
START RECORDING DECK
5 Engage its Record mode.
IMPORTANT:
●To edit, both the player and the recorder must be of the same colour system. Press your recorder's COLOUR SYSTEM button to select the appropriate colour system.
●For more information on
NOTES:
●All necessary cables can be obtained from your dealer.
●When you use this recorder as the player for editing, be sure to set "O.S.D." to "OFF" before starting (☞ pg. 8).
●NTSC tapes being played back in the NTSC [PAL mode (☞ pg. 29) cannot be dubbed to another recorder.
●When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or NTSC 4.43) with the COLOUR SYSTEM button (☞ pg. 28).
TV Receiver | Player | Your recorder | Recorder | Your recorder | TV Receiver |
VIDEO |
| AV Cable |
| AV Cable | VIDEO |
| (not provided) |
| (not provided) | ||
CHANNEL |
| CHANNEL | |||
|
|
| |||
RF Cable (provided) |
|
| RF Cable |
| |
|
|
|
| (provided) | |
| Recorder | Another recorder | Another recorder |
| |
|
|
| Player |
| |
