JVC HR-J580EK manual Other Problems

subsidiary information

SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION

53

OTHER PROBLEMS

1.Whistling or howling is heard from the TV during camcorder recording.

2.When scanning channels, some of them are skipped over.

3.The preset cannot be changed.

¥The camcorderÕs microphone is too close to the TV.

¥The TVÕs volume is too high.

¥Those channels have been designated to be skipped.

¥Recording is in progress.

Position the camcorder so its microphone is away from the TV. Turn the TVÕs volume down.

If you need the skipped channels, restore them.

Press to pause the recording, change presets, then press .to resume recording.

4.Channel settings that were made manually seem to have changed or disappeared.

5.No channels are stored in the VCRÕs memory.

¥After the manual settings were made, Auto Channel Set was performed.

¥The TV aerial cable was not connected to the VCR when Auto Set Up was performed.

¥The fully-wired 21-pin SCART cable was not connected between TV and the VCR when Preset Download was per- formed.

Perform manual setting again.

Turn off the VCR once and connect the TV aerial cable to the VCR properly, then turn on the VCR again. Then perform Auto Setup again (☞Êpg.Ê10).

Turn off the VCR once and connect the fully-wired 21-pin SCART cable to the VCR properly, then turn on the VCR again. Then perform Preset Download again (☞Êpg.Ê12).