JVC HR-J655EK setup guide Activate Repeat, Repeat Playback, Ntsc Playback, Next Function Memory

28ADVANCEDOPERATIONS (cont.)

Repeat Playback

1

4

7

LAY 1

REW

STOP

2 3

5 6

8 9

0

?

3

2

4

FF

PAUSE

Your video recorder can automatically play back the whole tape 50 times repeatedly.

1	START PLAYBACK
	Press PLAY.
	ACTIVATE REPEAT
2	PLAYBACK
	Press PLAY and hold for over 5 seconds, then release.
	● The Play indicator ( ) on the display panel blinks
	slowly.
	● The tape plays 50 times automatically, and then stops.
3	STOP PLAYBACK
	Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press within 2 seconds.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY.
	● "NTSC→PAL" appears on the screen for about 5
	seconds.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and tape remaining time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.
	● Depending on the type of TV, the top and bottom
	portions of superimposed displays may be cut off
	during NTSC playback.