JVC HR-S7800U manual 16 EN, Setting cable box output channel & brand

CABLE BOX SET

OFF

PRESS (5,°), THEN (OK)

PRESS (MENU) TO END

INITIAL SET

CLOCK SET

LANGUAGE ENGLISH GUIDE CHANNEL SET

=CABLE BOX SET

DBS RECEIVER SET

SELECT WITH (5,°) AND (OK)

PRESS (MENU) TO END

16 EN INITIAL SETTINGS (cont.)

Turn on the VCR and the TV, and select the VCR						2
channel 3 or 4 (or AV mode) on the TV.
		346				3
		2
						FF
POWER				MENU
					PLAY
	DIGITAL TBC/NR
S-VIDEO	VIDEO (MONO)L—AUDIO—R
	S-VHS ET	SP EP	CH	REC	STOP/EJECT PAUSE
		VCR		OK		4
		3–5

1	2	3		7
			2
4	5	6		5
7	8	9
	0		4

1

23467

34 3– 5

Setting cable box output channel & brand

After installation, set the cable box output’s channel and its brand correctly; otherwise, the Controller cannot work correctly.

1 Turn on cable box

Select a channel other than channel 9 on your cable box.

Access Main Menu screen on VCR

Press MENU.

Access Initial Set screen

On the front panel:

Press CH5° to move the highlight bar (arrow) to “INITIAL SET”, then press OK.

On the Remote:

Press SHUTTLE PLUS %Þ to move the highlight bar (arrow) to “INITIAL SET”, then press OK or

SHUTTLE PLUS #.

Access Cable Box Set screen

On the front panel: Press CH5° to move the highlight bar (arrow) to “CABLE BOX SET”, then press OK.

On the Remote:

Press SHUTTLE PLUS

%Þ to move the highlight bar (arrow) to “CABLE BOX SET”, then press OK or SHUTTLE PLUS #.

Select cable box output channel

Your selection depends on how your cable box is connected to your VCR.

If your cable box is connected to your VCR’s ANTENNA IN terminal on the rear

Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until the channel number representing the cable box’s output (CH2 – CH9) appears on the screen.

If your cable box is connected to your VCR’s AUDIO/VIDEO IN connectors on the front panel Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “ON F-1 (FRONT)” appears on the screen.

If your cable box is connected to your VCR’s AUDIO/VIDEO IN connectors on the rear panel Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “ON L-1 (REAR)” appears on the screen.

If you do not use a cable box

Press CH 5° on the front panel or SHUTTLE PLUS %Þ on the Remote until “OFF” appears on the screen.