JVC HR-S7800U manual 20 EN, Access DBS Receiver Brand Set screen, Enter DBS Receiver’s brand

DBS RECEIVER BRAND SET

51

DID YOUR DBS RECEIVER CHANGE TO CHANNEL 100? =YES

NO

PRESS (5,°), THEN (OK)

PRESS (MENU) TO END

DBS RECEIVER BRAND SET

4 0

PRESS NUMBER KEY (0–9)

THEN (OK) TO TEST PRESS (MENU) TO END

20 EN INITIAL SETTINGS (cont.)

					6		6
							7
							FF
POWER					MENU
						PLAY
	DIGITAL TBC/NR
S-VIDEO	VIDEO (MONO)L—AUDIO—R
	S-VHS ET	SP	EP	CH	REC	STOP/EJECT	PAUSE
			VCR		OK

Access DBS Receiver Brand Set screen

Press OK.

Enter DBS Receiver’s brand

On the Remote ONLY:

Press the appropriate Number keys to enter the brand code from the following list, then press OK.

The program currently received through the

DBS receiver appears for about 10 seconds.

1 2 3

2

4 5 6 7

7 8 9

0 4

1

67

OK

SHUTTLE PLUS %Þ

BRAND	CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

If the DBS receiver’s channel changes to the channel listed below for your brand, setting is complete

JVC = 100 ECHOSTAR = 100 PRIMESTAR = 55 SONY = 205 RCA = 205

Press OK and “DBS

RECEIVER CONTROL IS ON” appears on the screen for about 5 seconds, then it returns to the normal screen.

If the DBS receiver’s channel does not change as shown above

1Press SHUTTLE PLUS %Þ (or CH 5° on the front panel) to move the highlight bar (arrow) to “NO”.

2Press OK.

3Re-enter the correct code.

NOTES:

The Controller may not work with all types of DBS receiver. If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.

The VCR can only change the satellite channel through the Controller during timer recording.

If your DBS receiver cannot be operated with a remote control (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.

For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at 1-800-252-5722.