JVC HR-VP652U, HR-VP452U Oubleshooting, Timer again, Re-perform the VCR Plus+ setup, Procedure pg

46EN

TROUBLESHOOTING(cont.)

TIMER RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording won’t work.	● The clock and/or the timer have	Set the clock and/or timer correctly.
		been set incorrectly.
		● The timer is not engaged.	Press TIMER and check to make sure
			that äappears on the front display
			panel.
		● The VCR has not been set up properly.	Re-perform the set-up procedures.
2.	Timer programming won’t work.	● Timer recording is in progress.	Timer programming can’t be performed
			when timer recording is in progress.
			Wait until it finishes.
3.	ä and ] on the front display	● The timer is engaged but there’s no	Load a cassette with the record safety
	panel won’t stop blinking.	cassette loaded.	tab intact, or with the hole covered
			with adhesive tape.
4.	The cassette is automatically	● The loaded cassette has had its	Remove the cassette and cover its
	ejected, and ä and ] on the	record safety tab removed.	hole with adhesive tape, or replace it
	front display panel won’t stop		with a cassette on which the safety
	blinking.		tab is intact.
5.	ä blinks for 10 seconds and the	● TIMER has been pressed when there	Check the programmed data and re-
	timer mode is disengaged.	are no programs in memory, or the	program as necessary, then press
		timer record program information	TIMER again.
		has not been programmed correctly.
6.	The cassette is automatically	● The end of tape was reached during	The program may not have been
	ejected, the power shuts off and ä	timer recording.	recorded in its entirety. Next time
	and ]won’t stop blinking.		make sure you have enough time on
			the tape to record the entire program.
7.	We moved, and now VCR Plus+	● The receivable stations in the new area	Re-perform the VCR Plus+ setup
	doesn’t work properly.	are received on different channels than	procedure (☞ pg. 32).
		those in the previous area.
8.	“PROGRAM FULL” is displayed on	● All 8 programs of the VCR’s timer	Wait until a space in memory clears,
	the screen.	memory are used.	or cancel unnecessary program
			information (☞ pg. 36).
OTHER PROBLEMS

	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	When scanning channels, some of	● Those channels have been preset to	If you need the skipped channels,
	them are skipped over.	be skipped.	restore them (☞ pg. 15).
2.	The channel can’t be changed.	● Recording is in progress.	Press PAUSE to pause the recording,
			change channels, then press PLAY to
			resume recording.
3.	The remote control won’t operate	● The remote control brand setting is	Re-set the remote control to the
	my TV or cable box or DBS receiver.	incorrect.	correct brand (☞ pg. 41 or 42 or 43).
4.	Even though Auto or Semi-Auto	● The clock setting data received from	Select a different Host Channel during
	clock setting has been selected, the	the Host Channel is incorrect.	the Semi-Auto setting procedure
	clock is incorrect.		(☞ pg. 12), or perform the Manual
			setting procedure (☞ pg. 13).

ATTENTION:

This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR does not operate correctly switch its power off and unplug the power cord from the AC supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If everything appears normal resume operating the VCR as usual.