JVC HR-VP655U manual Access DBS Receiver

NUMBER

CH OK

1 2 3

2

4 5 6

7 8 9

0 4

EN21

	ACCESS DBS RECEIVER
	BRAND SET SCREEN
7 Press OK.
	SET DBS RECEIVER BRAND
	Press the appropriate	DBS RECEIVER BRAND SET
	NUMBER keys to enter the
8 DBS Receiver Code from
				4 0
	the following list, then
	press OK.
		PRESS NUMBER KEY (0–9)
		THEN (OK) TO TEST
		PRESS (MENU) TO END
	BRAND			CODE
	JVC (DISH Network)		51
	ECHOSTAR (DISH Network)		51
	PRIMESTAR		50
	SONY (DSS)		41
	RCA (DSS)		40
	● After OK is pressed, the program currently received
	through the DBS receiver will appear for about 10
	seconds.
	● If the DBS receiver's channel changes as follows,
	setting is complete. Press OK and "DBS RECEIVER
	CONTROL IS ON" appears on the screen for about 5
	seconds, then it returns to the normal screen.
	JVC [ 100
	ECHOSTAR [ 100

1

3 OK

SHUTTLE PLUS

PRIMESTAR [ 55

SONY [205

RCA [205

● If the DBS receiver's channel does not change as

shown above, press CH 5° or SHUTTLE PLUS %Þ

to move the highlight bar (arrow) to "NO", then press

OK. Re-enter the correct code.

NOTES:

●It is possible that the Controller will not work with all types of DBS receiver.

●If your DBS receiver doesn’t respond to the code, you can’t use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●The VCR can only change the satellite channel through the Controller during timer recording.

●If your DBS receiver is one that can’t be operated with a remote control (because it has no remote sensor), you can’t use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording.

●For customers in U.S.A.: If you are unable to set the Control- ler, please contact JVC toll free at 1-800-252-5722.