JVC HR-VP655U manual Express Timer Programming, SET Program Date, SET Channel Number

40ENTIMERRECORDING(cont.)

Express Timer Programming

Turn on the TV and select the VCR channel 3 or 4 (or AV mode).

You can directly program the VCR’s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞ pg. 8 or 11).

1	LOAD A CASSETTE
	Make sure the record safety tab is intact. If not, cover
	the hole with adhesive tape, then load it into the VCR.
	● The VCR comes on, and the counter is reset,
	automatically.
	ACCESS VCR PLUS+
	SCREEN
2 Press PROG.
	ACCESS PROGRAM
3	SCREEN
	Press START +/–. (If you’re		PROGRAM 1
	just starting out,		START		STOP
	“PROGRAM 1” appears.)
			– –:– –AM	=	– –:– –AM
			DATE		CH
			– –/– –/– –		– – –	SP
		PRESS (+/–, SP/EP, 8=DAILY,
		9=WEEKLY), THEN (0K)
		PRESS (PROG.) TO END
	SET PROGRAM START TIME
	Press START +/– to enter		PROGRAM 1
4 the time you want

START+/–

PROG.

1 2 3

4 5 6

7 8 9

0

1

STOP+/– DATE+/–

2

4

CH

	recording to start.		START		STOP
			8:00 AM	=	– –:– –AM
	● Press and hold START		DATE		CH
			– –/– –/– –		– – –	SP
	+/– to move in 30-
	minute increments, or	PRESS (+/–, SP/EP, 8=DAILY,
	press and release	9=WEEKLY), THEN (0K)
		PRESS (PROG.) TO END
	repeatedly to move 1
	minute at a time.
5	SET PROGRAM STOP TIME
	Press STOP +/– to enter the time you want recording to
	stop.

●Press and hold STOP +/– to move in 30-minute increments, or press and release repeatedly to move 1 minute at a time.

	SET PROGRAM DATE
	Press DATE +/–. (The current date is displayed on
6 screen. The date you enter appears in its place.)
7	SET CHANNEL NUMBER
	Press CH +/–.
	● If you are using a DBS receiver, see "ATTENTION
	FOR DBS RECEIVER USERS" on next page.
	● Holding down CH +/– rapidly scans through the
	channels.