JVC KD-AR400 manual Adjusting the sound, English, Indication, To do

Adjusting the sound 2 Adjust the setting.

You can adjust the sound characteristics to your preference.

1Select the item you want to adjust.

Each time you press the button, the adjustable items change as follows:

		BAS		TRE		FAD
	(bass)			(treble)		(fader)
		VOL		LOUD		BAL
	(volume)			(loudness)		(balance)
Indication			To do:			Range
BAS*1		Adjust the bass.			–06 (min.)
					+06 (max.)
TRE*1		Adjust the treble.			–06 (min.)
					+06 (max.)
FAD*2		Adjust the front			R06 (Rear only)
		and rear speaker
		balance.			F06 (Front only)
BAL		Adjust the left			L06 (Left only)
		and right speaker
		balance.			R06 (Right only)
LOUD*1		Boost low and high
		frequencies to			LOUD ON
		produce a well-
		balanced sound			LOUD OFF
		at low volume level.
VOL*3		Adjust the volume.			00 (min.)
					30 or 50 (max.)*4

*1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including “USER.”

*2 If you are using a two-speaker system, set the fader level to “00.”

*3 Normally the control dial works as the volume control. So you do not have to select “VOL” to adjust the volume level.

*4 Depending on the amplifier gain control setting. (See page 26 for details.)

To increase the level or turn on the loudness

To decrease the level or turn off the loudness

Indication pattern changes as you adjust the bass or treble.

Ex. 1: When you adjust “TRE” (treble)

Ex. 2: When you turn on the loudness

3Repeat steps 1 and 2 to adjust the other items.

To reset each sound mode to the factory

settings, repeat the same procedure and reassign the preset values listed in the table on page 22.

ENGLISH

23