Assigning names to the sources
You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and the external component.
After assigning a name, it will appears on the display when you select the source.
Sources | Maximum number of | |
characters | ||
| ||
|
| |
Station frequencies | Up to 10 characters (up to | |
| 30 station frequencies | |
| including both FM and AM) | |
|
| |
CDs* | Up to 32 characters (up to | |
| 40 discs) | |
|
| |
External component | Up to 8 characters |
*You cannot assign a name to a CD Text (and MP3 discs in the CD changer).
1 Select a source you want to assign a name to.
When you select a source, the
power automatically comes on.
2 While pressing D (DISP), press and
hold SEL (select) for more than 2 seconds.
The
3 Select the character set you want while the first character position is flashing.
Each time you press the
button, the character set
changes as follows:
(A – Z: capital) 
(a – z: small)
(1 – 9: numbers, and symbols)
4 Select a character.
• About the available
characters, see page 41.
5 Move the cursor to the next (or previous) character position.
6 Repeat steps 3 to 5 until you finish entering the name.
7 Finish the procedure while the last selected character is flashing.
ENGLISH
To erase the entered characters
Insert spaces using the same procedure described above.
Notes: |
• When you try to assign a name to the 41st disc, you
Ex.: When you select CD as the source cannot enter the text entry mode. In this case, delete unwanted names before assignment.
• When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.
31
